Agilent Power Supply Connections for Your CET Signal Conditioner Card Application Note 5990-6549EN c20140929 free download

File name Power Supply Connections for Your CET Signal Conditioner Card Application Note 5990-6549EN c20140929

Keysight Technologies Power Supply Connections for Your CET Signal Conditioner Card Application Note Power Requirement for CET Card The CET signal conditioner card Power is connected via a wire wrap of AWG28 wires to pins 11 and 12 of J6 of (referenced in this application note the CET card. There is another pair of power connections on J6 at pins 3 and 4. as CET card) can be powered from These are the power connections for the USB and do not provide power to the various sources. The recommended CET card itself. sources are discussed in the follow- ing sections. The input supply voltage to the CET card is +12 V @ 0.3 A. The selected source to provide the power needs to be controllable through the test plan execution. Power to the CET card must be uninterrupted for the Connector J6 duration of powered testing. If power to the CET card is disconnected, an 19 1 "unpowered" command must be issued before turning the power back on. 20 2 Figure 1. Connections on CET card (J6 connector) Table 1. Pin layout of J6 connector on CET card CET card (J6 connector) Wire color Wire type Remarks Pin 1 White USB D