TOSHIBA MJ-1011+(FIN) free download

File name MJ-1011+(FIN).pdf

File No. 3110009 General Precautions for Installation/Servicing/Maintenance The installation and service should be done by a qualified service technician. 1. When installing the Finisher MJ-1011 to the Plain Paper Copier, be sure to follow the instructions described in the "Unpacking/Set-Up Procedure for the MJ-1011" booklet which comes with each unit of the MJ-1011. 2. The MJ-1011 should be installed by an authorized/qualified person. 3. Before starting installation, servicing or maintenance work, be sure to unplug the copier first. 4. When servicing or maintaining the MJ-1011, be careful about the rotating or operating sections such as gears, pulleys, sprockets, cams, belts, etc. 5. When parts are disassembled, reassembly is basically the reverse of disassembly unless otherwise noted in this manual or other related materials. Be careful not to assemble small parts such as screws, washers, pins, E-rings, toothed washers to the wrong places. 6. Basically, the machine should not be operated with any parts removed or disassembled. 7. Delicate parts for preventing safety hazard problems (such as breakers, thermofuses, fuses, door switches, sensors, etc. if any) should be handled/installed/adjusted cor- rectly. 8. Use suitable measuring instruments and tools. 9. During servicing or maintenance work, be sure to check the serial No. plate and other cautionary labels (if any) to see if they are clean and firmly fixed. If not, take appropri- ate actions. 10. The PC board must be stored in an anti-electrostatic bag and handled carefully using a wristband, because the ICs on it may be damaged due to static electricity. Before using the wrist band, pull out the power cord plug of the copier and make sure that there is no uninsulated charged objects in the vicinity. 11. For the recovery and disposal of used MJ-1011s, consumable parts and packing ma- terials, it is recommended that the relevant local regulations/rules should be followed. 12. When the Finisher is to be carried, be sure to hold the locations shown in the figures. 13. Place the finisher as shown in the figure below making sure that the cord is not nipped. Copyright