Toshiba DP 8070/6570/5570/4580 free download

File name 8070SH.pdf

File No. 31110001 GENERAL PRECAUTIONS REGARDING THE INSTALLATION AND SERVICE FOR THE COPIER 8070/6570/5570/(***)4580 The installation and service should be done by a qualified service technician. 1. Transportation/Installation · When transporting/installing the copier, move it by the casters while lifting the stoppers. The copier is quite heavy and weighs approximately 250 kg (551 lb), therefore pay full attention when handling it. · Be sure to use a dedicated outlet with AC 115V or 120V/20A (220V, 230V, 240V/10A) or more for its power source. · The copier must be grounded for safety. Never ground it to a gas pipe or a water pipe. · Select a suitable place for installation. Avoid excessive heat, high humidity, dust, vibration and direct sunlight. · Also provide proper ventilation as the copier emits a slight amount of ozone. · To insure adequate working space for the copying operation, keep a minimum clearance of 80 cm (32") on the left, 80 cm (32") on the right and 10 cm (4") in the rear. 2. Service of Machines · Basically, be sure to turn the main switch off and unplug the power cord during service. · Be sure not to touch high-temperature sections such as the exposure lamp, the fuser unit, the damp heater and their periphery. · Be sure not to touch high-voltage sections such as the chargers, the transfer belt and the high- voltage transformer. · Be sure not to touch rotating/operating sections such as gears, belts, pulleys, fan, etc. · When servicing the machines with the main switch turned on, be sure not to touch live sections and rotating/operating sections. Avoid exposure to laser radiation. · Use suitable measuring instruments and tools. · Avoid exposure to laser radiation during servicing. - Avoid direct exposure to beam. - Do not insert tools, parts, etc. that are reflective into the path of the laser beam. - Remove all watches, rings, bracelets, etc. that are reflective. 3. Main Service Parts for Safety · The breaker, door switch, fuse, thermostat, thermofuse, thermistor, etc. are particularly impor- tant for safety. Be sure to handle/install them properly. 4. Cautionary Labels · During servicing, be sure to check the rating plate and the cautionary labels such as "Unplug the power cord during service", "Hot area", "Laser warning label" etc. to see if there is any dirt on their surface and whether they are properly stuck to the copier. (***) Model 4580 is only for NAD, ASD and MJD. 5. Disposition of Consumable Parts/Packing Materials · Regarding the recovery and disposal of the copier, supplies, consumable parts and packing materials, it is recommended to follow the relevant local regulations or rules. 6. When parts are disassembled, reassembly is basically the reverse of disassembly unless