Samsung SF-5100 free download

File name SF-5100 TECH MODE.pdf

3. Tech Mode 3-1 To Access TECH Mode In Tech mode, the technician can perform various tests to isolate the causes of a malfunction, and set the technical option features to customize the machine depending on the user's operation environment. To access TECH mode, press SETUP, #, 1, 9, 3, 4 in sequence, and the LCD displays `TECH' in the standby mode screen. While in TECH mode, the machine still performs all normal operations. To return to the normal user mode, press SETUP, #, 1, 9, 3, 4 in sequence in TECH mode or turn the power off, then back on. The technical options you have set in TECH mode are not changed unless you clear the machine's memory in TECH mode. To communicate via direct connection with another fax machine, press OHD/V.REQ followed by Start/Enter. 3-2 Tech Mode Options In TECH mode, press SETUP, then press or until `TECH MODE' appears in the display. Press Start/Enter. The following technical options are available. Note: If necessary, print System Data List in TECH mode. The list shows all current system data settings including the TECH MODE options. To print the system data list, press Report/Help, then press or ® until `SYSTEM DATA' appears in the display, and press Start/Enter. Dialing Mode Default = Tone Select the dialing mode according to the user's line status. Send Fax Level Default = -12 dBm You can set the level of the transmission signal. Typically, the Tx level should be under -12 dBm. The level within the range of 1 to -15 dBm is acceptable. Enter the desired value using the number keypad. Modem Speed Default = 14.4 kbps Select the maximum modem speed of 14400, 12000, 9600, 7200, 4800, or 2400 bps. When the modem speed is set to 14400 or 12000, the Rx speed can be either V.33 or V.17 speed. When it is set to 9600 or 7200, the Rx speed can be either V.29 or V.27ter speed. When set to 4800 or 2400, the Rx speed can any V.27ter speed. RCV Fax Level Default = -43 dBm The reception level may be too low due to the cable losses. If it is set to -43 dBm, the reception sensitivity will be between 0 and -43 dBm. If it is set to -48 dBm, the reception sensitivity will be between 0 and -48 dBm. Samsung Electronics 3-1 Tech Mode Flash Time Default = 600 milliseconds Set the flash time to 80, 280, or 600 milliseconds. Silence Time Default = Unlimited In ANS/FAX mode, after a call is picked up by the answering machine, the machine monitors the line. If a period of silence is detected on the line at any time, the call will be treated as a fax message and the machine begins receiving. Silence detection time is selectable between limited (about 12 seconds) and unlimited time. When `12 sec' is selected, the machine switches to receiving mode as soon as it detects a period of silence. When `Unlimited' is selected, the machine waits until the answering operation is concluded even though a period of silence is detected. After the answering operation is concluded, the machine switches to receiving mode. Error Rate When the error ra