Toshiba BD-1550 free download

File name 1550SH.PDF

SERVICE HANDBOOK PLAIN PAPER COPIER PAPER FEEDING UNIT Click the Page Only button to close the overview area of the window. 1550 MY-1004 Click the Bookmarks and Page button to open the Contents and display bookmarks created for the document. Click a bookmark's name to go to the Page marked by that bookmark. Click the Thumbnails and Page button to open the overview area and display thumbnail images of each document page. Click a thumbnail to go to the page marked by that thumbnail. Copyright TOSHIBA CORPORATION 1995 ALL RIGHTS RESERVED GENERAL PRECAUTIONS REGARDING THE INSTALLATION AND THE SERVICE OF THE 1550/MY-1004 1. Transportation/Installation · When transporting/installing the copier, using two persons, be sure to use the positions as indicated below. The copier is fairly heavy and weighs approximately 35 kg (76.8 lb), therefore pay full attention when handling it. 4 portions 2. Installation · Be sure to use a dedicated outlet with AC 115V/15A (220V, 240V/10A) or more for its power source. · The copier must be grounded for safety. Never ground it to a gas pipe or a water pipe. · Select a suitable place for installation. Avoid excessive heat, high humidity, dust, vibration and direct sunlight. · To insure adequate working space for the copying operation, keep a minimum clearance of 80 cm (31.5") on the left, 80 cm (31.5") on the right and 10 cm (3.9") in the rear. 3. Service of Machines · Basically, be sure to turn the main switch off and unplug the power cord during service. · Be sure not to touch high temperature sections such as the exposure lamp, the fuser unit, the damp heater and their periphery. · Be sure not to touch high-voltages sections such as the chargers and the high-voltage transformer. · Be sure not to touch rotating/operating sections such as gears, belts, pulleys, etc. · When servicing the machines with the main switch turned on, be sure not to touch live sections such as the lamp terminal etc. · Use suitable measuring instruments and tools. 4. Main Service Parts for Safety · The thermofuse, thermistor, fuse, breaker and door switch, etc. are particularly important for safety. Be sure to handle/install them properly. 5. Notice Labels · Be sure to check the rating plate and the notice labels such as "Unplug the power cord during service", "Hot area", etc. to see if there is any dirt on their surface or if they are properly stuck to the copier during servicing. 6. Disposition of Consumable Parts/Packing Materials · Regarding the recovery and disposal of the copier, consumable parts and packing materials, it is recommended to follow the relevant local regulations or rules. 7. When parts are disassembled, reassembly is basically the reverse of disassembly unless otherwise noted in this manual or other related documents. Be careful not to reassemble small parts such as screws, washers, pins, E-rings, toothed washers in the wrong places. 8. Basically, the machine should not be operated with any parts removed or disassembled.