Harman/Kardon AVR320 free download

File name HarmanKardon-AVR320 rec.pdf

harman/kardon AVR320 A/V DOLBY DIGITAL RECEIVER PRELIMINARY SERVICE MANUAL CONTENTS ESD WARNING...2 LEAKAGE TESTING...3 BASIC SPECIFICATIONS...4 FRONT PANEL CONTROLS...5 REAR PANEL CONNECTIONS...10 REMOTE CONTROL FUNCTIONS...12 TROUBLESHOOTING GUIDE...15 UNIT EXPLODED VIEW...16 EXPLODED VIEW PARTS LIST...17 BULLETIN H/K2002-03...19 BULLETIN H/K2002-07...20 BLOCK DIAGRAM...21 ELECTRICAL PARTS LIST...22 SCHEMATICS...71 harman/kardon, Inc. 250 Crossways Park Dr. Woodbury, New York 11797 Rev1 ­ 11/2002 Some semiconductor (solid state) devices can be damaged easily by static electricity. Such components commonly are called Electrostatically Sensitive (ES) Devices. Examples of typical ES devices are integrated circuits and some field effect transistors and semiconductor "chip" components. The following techniques should be used to help reduce the incidence of component damage caused by static electricity. 1. Immediately before handling any semiconductor component or semiconductor-equipped assembly, drain off any electrostatic charge on your body by touching a known earth ground. Alternatively, obtain and wear a commercially available discharging wrist strap device, which should be removed for potential shock reasons prior to applying power to the unit under test. 2. After removing an electrical assembly equipped with ES devices, place the assembly on a conductive surface such as aluminum foil, to prevent electrostatic charge build-up or exposure of the assembly. 3. Use only a grounded-tip soldering iron to solder or unsolder ES devices. 4. Use only an anti-static solder removal device. Some solder removal devices not classified as "anti-static" can generate electrical charges sufficient to damage ES devices. 5. Do not use freon-propelled chemicals. These can generate electrical change sufficient to damage ES devices. 6. Do not remove a replacement ES device from its protective package until immediately before you are ready to install it. (Most replacement ES devices are packaged with leads electrically shorted together by conductive foam, aluminum foil or comparable conductive material.) 7. Immediately before removing the protective material from the leads of a replacement ES device, touch the protective material to the chassis or circuit assembly into which the device will be installed. CAUTION : Be sure no power is applied to the chassis or circuit, and observe all other safety precautions. 8. Minimize bodily motions when handling unpackaged replacement ES devices. (Otherwise harmless motion such as the brushing together or your clothes fabric or the lifting of your foot from a carpeted floor can generate static electricity sufficient to damage an ES devices.