Metex M-3640D free download

File name Metex3640D.pdf

Not Recommended for New Installations. Please contact Technical Support for more information. True RMS Handheld Multimeter Model M-3640D Documentation Number M3640D1598 B&B Electronics Mfg. Co. Inc. 707 Dayton Road -- P.O. Box 1040 -- Ottawa, IL 61350 PH (815) 433-5100 -- FAX (815) 433-5104 Internet: http://www.bb-elec.com [email protected] [email protected] B&B Electronics -- May 1997 Manual Documentation Number M3640D1598 Cover Page B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350 PH (815) 433-5100 -- FAX (815) 433-5104 ATTENTION: METEX USERS This addendum contains corrections and additions to the user's manual. Paragraph 6-12-2, page 32, of the M-3640D Digital Multimeter manual refers to two computer programs: METEX and Scopeview. These programs are no longer available and have been replaced by METVIEW. This program works with Windows 3.11, Windows 95, and Windows NT. Please use the following Installation information and NOT the information in the manual. The Hardware Interfacing information in paragraph 6-12-1 is correct. Installing the Supplied Software We have included a Windows 95/NT program, named METVIEW.EXE, to log data collected with your meter. To install the software on your hard drive: 1. 2. 3. Insert the disk in drive A. Click the start button in the lower left corned of the screen and choose "Settings I Control Panel I Add / Remove Programs". Click the install button and follow the directions. Using the Software To run the software after it has been installed, click the start button in the lower left corner of the screen and choose "Programs I Metex I Metex". After starting the metex program, click the setup button. A dialog box appears that allows you to select the serial communications port, sampling interval, and logging file. Note that the logging file can only be changed when the "Enabled Data Logging" check box is checked. The filename may be typed in or you can click the browse button to select where the file should be located. Once you have completed the setup, click the OK button. To start collecting data from the meter, click the button labeled "start". Data is read from the meter at the sampling interval that was selected when you setup the software. If data logging is enabled, the data is written to a disk file. To stop collecting data, click the button labeled "stop". Note that this is the same button as the start button. Addendum Manual Documentation Number M3640D1598 B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350 PH (815) 433-5100 -- FAX (815) 433-5104 Format of the Data File The data is written to the logging file as fixed length records. The format is: HH:MM:SS XX######YYYY where HH:MM:SS is the hour (24 hour format), minute and second when the sample was taken, XX is the meter function, ###### is the value read from the meter, and YYYY is the units. This file can be read by a program, such as Microsoft Excel, to analyze the data or print out a chart. Telephone...