Keithley 7169 901 01A free download

File name 7169_901_01A.pdf

Model 7169 General Purpose Scanner Card Instruction Manual Contains Operating and Servicing Information WARRANTY LIMITATION OF WARRANTY STATEMENT OF CALIBRATION Model 7169 General Purpose Scanner Card Instruction Manual 01989, Keithley Instruments, Inc. All rights reserved. Cteveland, Ohio, U.S.A. First Printing, July 1989 Document Number: 716Y-901.01 Rev. A All Keithley product names are trademarks or registered trade, marks of Keithley Instruments, Inc. Other brand and product names are trademarks or registered trademarks of their respective holders. SAFETY PRECAUTIONS The following safety precautions should be observed before using the Model 7169 and the associated instruments. This card is intended for use by qualified personnel who recognize shock hazards and are familiar with the safety precautions required to avoid possible injury. Read over this manual carefully before using the card. Exercise extreme caution when a shock hazard is present at the test cir- cuit. User-supplied lethal voltages may be present 011the PC board. The American National Standards Institute (ANSI) states that a shock haz- ard exists when voltage levels greater than 30V RMS or 42.4V peak are present. A good safety practice is to expect that hazardous voltage is present in any unknown circuit before measuring. Do not exceed500V peak between any two pins or between any pin and earth ground. Inspect the connecting cables and test leads for possible wear, cracks, or breaks before each use. For maximum safety, do not touch the test cables or any instruments while power is applied to the circuit under test. Turn off the power and discharge any capacitors before connecting or disconnecting cables from the card. Do not touch any object which could provide a current path to the com- mon side of the circuit under test or power line (earth) ground. Always make measurements with dry hands while standing on a dry, insulated surface capable of withstanding the voltage being measured. Do not exceed the maximum signal levels of the card, as defined in the specifications and operation section of this manual. Model 7169 20 Form C Switch Card CHANNELS PER CARD: 2.0 independent Form C. All poles available at connectors. Replacement of factory installed jumper allows current limit resistor in series with common of each channel. On- card bus allows for addition of jumper to change configuration from switch to multiplex. Bus also allows channel interconnection. CONNECTOR TYPE: 3 x 20 pin mass termination. RELAY DRIVE CURRENT: 3OmA per relay typical. MAXIMUM SIGNAL LEVEL: 500V peak, 0.5A rms switched, 1A rms carry, 1OW (resistive load only). CONTACT LIFE: >108 closures cold switching; >107 closures at maximum signal levels. CONTACT RESISTANCE: <2Q to rated life. CO