Keithley 2000-903-01 B Dec 1999 QRG free download

File name 2000-903-01_B_Dec_1999_QRG.pdf

www.keithley.com Model 2000 Multimeter Quick Reference Guide 2000-903-01 Rev.B / December 1999 A G R E A T E R M E A S U R E O F C O N F I D E N C E Model 2000 Multimeter Quick Reference Guide 1995, Keithley Instruments, Inc. All rights reserved. Cleveland, Ohio, U.S.A. Second Printing, December 1999 Document Number: 2000-903-01 Rev. B Table of Contents Safety Precautions ... 1 Introduction ... 5 Front Panel Operation Summary ... 6 Remote Operation Summary ... 22 Safety Precautions The following safety precautions should be observed be- fore using this product and any associated instrumenta- tion. Although some instruments and accessories would normally be used with non-hazardous voltages, there are situations where hazardous conditions may be present. This product is intended for use by qualified personnel who recognize shock hazards and are familiar with the safety precautions required to avoid possible injury. Read the operating information carefully before using the product. The types of product users are: Responsible body is the individual or group responsible for the use and maintenance of equipment, for ensuring that the equipment is operated within its specifications and operating limits, and for ensuring that operators are adequately trained. Operators use the product for its intended function. They must be trained in electrical safety procedures and proper use of the instrument. They must be protected from elec- tric shock and contact with hazardous live circuits. Maintenance personnel perform routine procedures on the product to keep it operating, for example, setting the line voltage or replacing consumable materials. Maintenance procedures are described in the manual. The procedures explicitly state if the operator may perform them. Otherwise, they should be performed only by service personnel. Service personnel are trained to work on live circuits, and perform safe installations and repairs of products. Only properly trained service personnel may perform installa- tion and service procedures. Exercise extreme caution when a shock hazard is present. Lethal voltage may be present on cable connector jacks or 1 test fixtures. The American National Standards Institute (ANSI) states that a shock hazard exists when voltage lev- els greater than 30V RMS, 42.4V peak, or 60VDC are present. A good safety practice is to expect that hazard- ous voltage is present in any unknown circuit before measuring. Users of this product must be protected from electric shock at all times. The responsible body must ensure that users are prevented access and/or insulated from every connection point. In some cases, connections must be ex- posed to potential human contact. Product u