Keithley PA-633 (A - Feb 2000)(4200-TMB) free download

File name PA-633 (A - Feb 2000)(4200-TMB).pdf

Keithley PreAmp Adapter Installation Model 4200-TMB Triaxial Mounting Bracket Packing List Introduction WARNING Theprocedures in packing are contained this list intended use qualified for by service personnel Do perform only. not these procedures unless qualified do Failure rec- to so. to and ognize observe normalsafety precautionscouldresult personal in injury death. or This document provides installation instructions for the Keithley Model 4200-TMB. Read through this document and make sure all components required to complete the installation are available before proceeding. NOTE The Model 4200 comes with a toolkit containing all tools required to properly install a Model 4200-TMB as described in this document--no special tools are required. The Model 4200-TMB is intended to provide a secure mounting bracket for mounting the Model 4200-PA PreAmp on a probe station or test fixture triaxial connector plate. The Model 4200-TMB is designed to be compatible with the HP 04156-60002 connector plate or any other connector plate designed for use with HP 04155-61602 Kelvin Triaxial Cables. See Figure 1 for connector plate template. Figure 1 Connector plate template M3 x 0.5 11.3 DIA. 3.2 DIA. (2 places) (2 places) (1 place) 10.3 2.8 14 11 11 14 NOTE Dimensions are shown in millimeters (mm). PA-633 Rev. A / 2-00 Installation Use the following procedure for installing each 4200-TMB onto a probe station connector plate. WARNING Turn power off all from connected instrumentation disconnect