Keithley 7002 903 01B Quick Reference Guide free download

File name 7002_903_01B_Quick_Reference_Guide.pdf

Model 7002 Switch System Quick Reference Guide Model 7002 Switch System Quick Reference Guide 1993, Keithley Instruments, Inc. All rights reserved. Cleveland, Ohio 44139 U.S.A. Document Number: 7002-903-01 Rev. B / 4-00 Table of Contents Safety Precautions...1 Introduction...3 Operation Summary ...4 Menu Structures ...16 Default Conditions ...21 Error and Status Messages ...24 Status Registers...27 IEEE-488.2 Common Commands ...31 SCPI Command Subsystems ...33 Safety Precautions The following safety precautions should be observed before using this product and any associated instrumentation. Al- though some instruments and accessories would normally be used with non-hazardous voltages, there are situations where hazardous conditions may be present. This product is intended for use by qualified personnel who recognize shock hazards and are familiar with the safety pre- cautions required to avoid possible injury. Read the operating information carefully before using the product. The types of product users are: Responsible body is the individual or group responsible for the use and maintenance of equipment, for ensuring that the equipment is operated within its specifications and operating limits, and for ensuring that operators are adequately trained. Operators use the product for its intended function. They must be trained in electrical safety procedures and proper use of the instrument. They must be protected from electric shock and contact with hazardous live circuits. Maintenance personnel perform routine procedures on the product to keep it operating, for example, setting the line volt- age or replacing consumable materials. Maintenance proce- dures are described in the manual. The procedures explicitly state if the operator may perform them. Otherwise, they should be performed only by service personnel. Service personnel are trained to work on live circuits, and per- form safe installations and repairs of products. Only properly trained service personnel may perform installation and service procedures. Exercise extreme caution when a shock hazard is present. Le- thal voltage may be present on cable connector jacks or test fixtures. The American National Standards Institute (ANSI) states that a shock hazard exists when voltage levels greater than 30V RMS, 42.4V peak, or 60VDC are present. A good safetypracticeistoexpectthathazardousvoltageis present in any unknown circuit before measuring.