MITSUBISHI VZ9 Chassis free download

File name VZ9_Chassis.rar

VZ9 Chassis Technical Training Chapter 1 Power Supply Last month's Expander described the Video/Color source for Standby Supplies, and D951 the source circuitry changes in the VZ9 chassis. This month's for Switched Supplies. Although D951 is only used article covers changes in the VZ9 Power Supply and when the set is switched On, it is connected directly Convergence Circuitry. Although the circuits are to the AC line and outputs approximately 170 volts similar to that in the VZ7 and VZ8 chassis, there are as long as the set is plugged in. differences. Transformer T952 provides isolation for the Standby Power Supply Supplies. D952 generates a STBY 14V supply. The The above illustration shows a Simplified Block Dia- STBY 14V supplies three circuits: gram of the VZ9 Power Supply circuitry. Two bridge 1) A 9 Volt Regulator generating STBY 9V. rectifiers are used, D952 and D951. D952 is the 2) A 5 Volt Regulator generating STBY 5V. 3) Provides power for the ON/OFF circuitry. VZ9 Chassis Technical Training The ON/OFF circuitry also receives Start Up volt- ON/OFF Circuitry age from the half wave rectification at one of the AC As stated earlier, the Start Up voltage source is from inputs of D951. When the set is switched On, the one AC input of D951. The voltage is directed ON/OFF circuitry directs the Start Up voltage to a through R964 to the collector of Q9A79 and the Switch Mode Regulator, the source of all Switched collector of the Photo Transistor in PC952. When Supplies. the set is switched On, the P-ON1 line from the Con- trol Circuitry goes High. The High drives Q980 into T951 provides isolation for the Switched Supplies conduction, lighting the LED in PC952. Light from generated at the secondary windings of the trans- the LED: former. Four Switched supplies are generated by 1) Turns the Photo Transistor On. rectifying the signals from the secondary windings: 2) Which turns ON Q9A79.