Text preview for : NSE8-031.PDF part of NOKIA NSE8-031 NOKIA Mobile Phone Nokia_3210 NSE8-031.PDF



Back to : NSE8-031.PDF | Home

CONFIDENTIAL 1 (2)




Nokia Mobile Phones Service Bulletin No. SB-031/15.02.00
Technical Support, Europe & Africa

NSE-8


NEW SERVICE SOFTWARE VERSION 271.01.00

New service software version 271.01.00 has been released for NSE-8
phones.

Changes made from version 241.11.00 to version 271.01.00:

- Multi SIM Locks handling in Phone Identity dialog improved
- Channel numbers editable in TX power side channel tuning
- Product specific delay before software reset added.
- Support for non continuous SIM lock programming data (France Telecom)
- Factory settings are now always done in local mode
- Support for ROM-6 added
- During flashing user is warned, if FLS-1 licenses are below warning limit
- In MCU Self-test's dialog "Failed" text is replaces with more visible
"**Failed**"
- Cancel selection added to Restore Defaults prompt after flashing
- Old GSM and T9 files are deleted before saving user settings during
flashing
- In Warranty State month zero is no longer accepted
- Notices much faster, if SIM is not inserted in SCM edit dialog
- Fixed cases where TX power level was not always correct when TX I/O
tuning is started. BASE and TEST levels removed from power level
selection in TX I/O Tuning dialog
- In MCU Self tests dialog fixed power off dialog title
- User setting recovery from failed flashing
- User settings are tried to write phone a bit harder (retry)
- After flashing self-tests testing and flash authority id is retried after reset,
if they at first fail
- DSP Alive test added after flash
- Improvement when flashing with NT (ealier rubbish was written to
TESLA.INI during flashing with NT)
- Erase limits can be market area specific
- Target base level is updated when base level calculation is used while
tuning TX power levels
- Saving is enabled after calculate, if levels are in order while tuning TX
power levels
- GoNoGo test interface support added
- Improvement to auto lock information displaying
- Sleep Test supports multiple tests without closing dialog
- User is asked to put power on after power off test in Sleep Test
- IMEI and SIM Locks can be set once with Both button in Phone Identity
dialog
- Check box for manual entry added in Phone Identity dialog



NSE-8 SB-031
CONFIDENTIAL 2 (2)




- ActRepair entry is changed to C:\temp in TESLA.INI
- Multiline dealer notes are saved correctly during flashing
- Audio levels increased to 255 in Internal Audio Test dialog and set default
frequency
- TXC Compensation removed from Tuning menu


CODE DESCRIPTION
0775212 SERVICE SW NSE-8/9 3'' DISK


Note: Before installing the Service Software, make sure that you have
installed WinTesla application version 6.03 or later.




NSE-8 SB-031