Text preview for : 9035KB-TE.pdf part of MAKITA 9035KB-TE MAKITA 9035KB-TE.pdf
Back to : 9035KB-TE.pdf | Home
T ECHNICAL INFORMATION
Models No. 9035KB
New Tool
Description Finishing sander
CONCEPTION AND MAIN APPLICATIONS
Developed as the compact type Finishing sander, wherein the
built-in dust collecting function protects the operator from
ruining his health and further provides less vibration and the
longer continuous operation.
Specifications
Volt(V) Current(A) Frequency(HZ) Continuous rating input(W)
100 5.5 50, 60 520
No load speed 5500 RPM
Pad size 93 x 185 mm
Overall length of machine 270 mm
Net Weight 3 kg
Power supply cord 2.5m
Standard equipment
Sanding paper set--------One set(for processing wood)
(Particle size : #60, #100, #150 --- 2 pieces for each)
Optional accessories
Sanding paper[Size : 93 mm x 228 mm(Three-divided of standard size)]
Particle size #60, #100, #150------ One set of the same type 10 pieces(for processing wood)
Features and benefits
1. The built-in dust proof function enables the healthy operation for human body without generating
dust.(No similar product in the same type made in domestic)
2. The large circle motion with the orbit diameter of 5 mm and 5500 RPM/min. enable the extremely high
working efficiency. (See the page 2/3 for the comparison with other models.)
3. The light weight, compact model and easy-to-handle structure are most suitable for the longer continuos
operation.
4. The double insulation structure gives no concern for getting an electrical shock.
5. For polishing the undercoating and finish-coating of any wooden products, finishing the joint on the
plaster board etc., surface-finishing of the stone material, and if the paper for metal is attached, it can be
used for removing the rust on the metal product, polishing the undercoating and removing the coat.
The standard equipment for the tools shown may differ from country to country.
Repair
1) Assembling of motor
a) Make fit the key groove of the fan to the position of pin 4 inserted into the armature shaft while
lapping the fan 80 on the separator and use the arbor press for getting the right angle to insert the fan
80 and the armature shaft. At this time simultaneously insert the ball bearing.
b) Assemble the armature while using care not to drop the flat washer 14 at rear of armature with the
motor housing faced up.
c) Do not insert the fan 80 into the armature twice. (If the fan 80 made from aluminum is disconnected
after it has been inserted once, the inner diameter is enlarged, the fastening allowance will be shortage
when re-inserting and thereby the large clearance of the hole can be easily made.)
2) Assembling of the frame
a) Fasten the pan head screw while the cover plate is being closely touched with the frame.
3) Inserting the rubber pin 4
a) The rubber pin 4 for protecting the ball bearing from turning, which are at front/rear of armature
and gear bearing, should be inserted in the deepest.
4) Base complete
a) Although the base complete is normally shipped as the repairing parts with the base and sponge
rubber being connected, read thoroughly the following notes beforehand for replacing only the
sponge rubber.
Note ) Evenly apply the thin layer of adhesive(three cement #100) on both faces of the base and sponge
rubber, and if the adhesive is dried in a degree that it cannot adhere on your finger, carefully connect
them in their precise positions in a way that the edge and the center may not float. It is desirable not
to move them for more than 2-hr after adhesion.
Note that the parts no. of the sponge rubber and adhesives are as follows :
Sponge rubber =>No. 4211408
The three cement =>No. 5310100