NSE8-043.PDF part of NOKIA NSE8-043 NSE8-043.PDF, NOKIA Mobile Phone Nokia

Text preview for : NSE8-043.PDF part of NOKIA NSE8-043 NOKIA Mobile Phone Nokia_3210 NSE8-043.PDF

Back to : NSE8-043.PDF | Home

CONFIDENTIAL 1 (2)

Nokia Mobile Phones Service Bulletin No. SB-043/25.08.00
Technical Support, Europe & Africa

NSE-8

NEW SERVICE SOFTWARE VERSION 311.01.00

New service software version 311.01.00 has been released for NSE-8
phones.

Changes made from version 271.02.00 to version 311.01.00:

- Updating MTC product verification feature removing blank lines and
adding the last bytes of the GSM picture
- Enable editing of the channel low and channel high thresholds in the TX
power side channel tuning
- Extra Games product profile has been added to the product profile dialog
- Fixed Product Code and Basic Product Code checks in Production Data
Edit dialog
- Fixed TX I/Q Tuning so that Amplitude or Phase Difference cannot be
tuned out of range
- Band change works correctly during phone change
- Added DSP init after TX I/Q tuning
- Added "Add SIM" and "Clear SIM" buttons to Phone Identity dialog to
allow manual entering of multi-index SIM-lock data
- Added 6 digit dongle serial number support
- Added hourglass to ADC Readings dialog during data reading
- Error message added, if security code check fails in User Setting dialog
- Removed Call Simulation from the menu
- Added Product/Initialise/Communication menu selection. This can be
used to set phone back to test mode without resetting phone
- Faultlog scanning speeded up by optimising version check
- More informative error messages added to Phone Identity dialog, also
some validity checks added. File name is generated from IMEI when data
is saved
- Restore User Defaults corrected not to show market area, if
corresponding Voice Mail Box is not present
- Buzzer level maximum changed to 127 in Internal Audio Loops dialog
- Software/Sleep Mode Test ... added for all products and all dongles
- Added AFC and PSW slope value check to lower band of multi band
phones
- Improvement to dead phone flashing (dialogs became modeless during
dead phone flashing)
- Improvement to SCM Edit (caused earlier crashes with some SIMs)
- Cancel button works also after flashing when phone communication could
not be started
- Improvement to PPM file reading (caused stack overflow with some PPM
files)

NSE-8 SB-043
CONFIDENTIAL 2 (2)

- Improvement to Flash dialog ("..." button opened earlier from directory of
previously used phone type)
- Improvement to restoring speed dials to SCM entries
- When ADC Readings dialog is opened phone is put to local mode, if not
already
- Improvement to RSSI Reading. Tuning values also read when local mode
selected from Product/Initialise/Local Mode
- Flash dialog do not any longer disappear during flashing behind other
windows

CODE DESCRIPTION
0775212 SERVICE SW NSE-8/9 3'' DISK

Note: Before installing the Service Software, make sure that you have
installed WinTesla application version 6.03 or later.

NSE-8 SB-043