Text preview for : Manual_Daewoo_Flashing_tool.pdf part of PANASONIC TX-29PM1P SERVICE MANUAL



Back to : TX-29PM1P.part1.rar | Home

Manual_Daewoo_Flashing_tool REVISION 02.00 Chassis CP-521F 1. Hardware Installation a. Turn Off computer b. Connect I2C Interface Please connect I2C Interface to the LPT computer slot. ! This installation requires ­ Microsoft.NET Framework Version 2.0 - it is available at http://www.microsoft.com/net

LPT Slot

I2C Interface connected

-

c. Turn On computer.

2. Software installation - Run DF1_2Setup.exe file. And next follow the installer command

- Important is the last step of installation ­ Restart computer now

1 of 4

Manual_Daewoo_Flashing_tool REVISION 02.00 Chassis CP-521F 3. Software configuration. Choose - Settings -> Interface -> Single Master (default Single Master)

Choose - Settings -> Transmission speed -> 50kbps (default is 100kbps, but with this speed with some hardware configuration errors can appear ­ at that time please change transmission speed to 50kbps )

Choose - Settings -> IC type -> N1D 128 (see at table 5.)

Choose - Settings -> Port -> LPT1 (depends on your hardware configuration. Normally is LPT1)

2 of 4

Manual_Daewoo_Flashing_tool REVISION 02.00 Chassis CP-521F 4. Chassis CP-521F family MICOM programming a) By Open Hex File button choose correct version of MICOM software (hex software can be at different directory, than you can see on the picture depends on where you placed hex file for flashing downloaded before). Default c:\Program Files \Daewoo Flashing 1.2\HEX files\...

b) Please connect I2C Interface to the chassis Do not connect SingleMaster interface to TV Set without connecting it to the computer

c) Please connect chassis to the power supply d) Turn On the chassis (chassis should be assembled with a CRT) e) STBY led should be lighted Important: Please observe led when led is starting to light after 3-4sec. from that push button Flash! ­ flashing process well started. After some elapsed time you should receive OK. Information for all indicators and Flashing succesfully completed!

f) Turn Off the chassis ­ programming process is finished.

3 of 4

Manual_Daewoo_Flashing_tool REVISION 02.00 Chassis CP-521F 5.MICOM types Table 5. MODELS TX-29PM1D TX-29PM1F TX-29PM1P Part Number TDA21HD01-W TDA21HD01-W TDA21HD01-E MICOM type N1D 128 N1D 128 N1D 128 SW file CP521F_PANA_10_3_WEST_ver00_3614_03_06.hex CP521F_PANA_10_3_EAST_ver00_3614_03_06.hex

Chassis CP-521F

6. Remark Do not connect SingleMaster interface to TV Set without connecting it to the computer. If during programming time you receive Error information * please try program one more time (push Flash! Button). (sometimes especially at Erasing Flash process few times of Start program is needed), * important is timing ­ Turn On chassis and Start flashing (time of pushing Flash! Button), see point 4-e * try change transmission speed (point 3) * check MICOM supply voltage (digital part 1,8V and 3,3V) all must be correct.

4 of 4