Text preview for : Crown-D60 pwramp.pdf part of Crown D60 power amplifier



Back to : Crown-D60 pwramp.pdf | Home

.

_

-. 2

1.2 SPECIFICATIONS 1.2.1 STEREO SPECIFICATIONS

Output Power

28 watts per channel minimum RMS (both channels o p e r ating) into an 8 ohm load over a bandwidth of 20Hz-20KHz at a rated RMS sum total harmonic distortion of 0.05% of the fun-' damental output voltage.

Frequency Response ±0. 1dB 20Hz-20KHz at 1 watt into 8 ohms; . ±1.2d bB 5Hz-100KH z at 1 watt into 8 ohms.

1
l

Rower

35 watts RMS into 8 ohms, per channel, both channels operating, 0.1% total harmonic distortion. *Les s than 0.001% from 20Hz-400Hz , and increasing linearly to 0.05% at 20KHz at 28 watts RMS per channel into 8 ohms. Less than 0.05% from 0.01 watts to 0.25 watts, and less than 0.01% from 0.25 watts to 28 watts into 8 ohms per channel. 6 volts per microsecond (slewing rate is the maximum valueofthefirstderivativeofthe output signal, or the maximum slope of the output signal). Greater than 400, DC 400Hz into 8 ohms. Less than 15 milliohms in series with less than 3 microhenries. Rated for 8 ohm usage; safely drives any load including completely reactive loads, 20. 6±2% or 26.3 ±.0.2 dbB maximum gain. at 0.75 volts ± 2% for 28 watts in to o8 ohms. Unbalanced, dual channel.

Harmoni cd Distortion I.M. Distortion (60Hz-7KH z 4:l) Slewing Rate Damping Factor Output Impedance Load Impedance Voltage Gain Input Sensitivtty Output Signal

PARTS LIST, D-60 Page 2

Schematic Designation R115, R215 R116, R216 R117, R217 R119, R 2 1 9 R125, R225 R120, R220 R127, R227 R121, R221 R122, R 2 2 2 R123, R223 R126, R226 R132, R232 *R135, R 2 3 5

Description 4.7K ohm ½ watt 10%
18K ohm ¼ watt 10%

Crown Part # 1640 2633 2873
3299

Other Information

180 ohm ¼ watt 10%
5.6 ohm ½ watt 5% 120 ohm ½ watt 5% Film 100 ohms ½ watt 10% 2.2K ohm ½ 1 750 ohm 3.3K w a t t 1 0 %

3837 1007

2629

W h e n IC u749 is used, must be connected from pins 1 to 7 and 7 to 13 on IC W h e n IC u739 is used and instability occurs, resistor must be connected from pins 1 to 7 and 7 to 13 on IC

*R135, R 2 3 5

10K ohm ¼ watt 10%

2631

R5 R13 4102, Q202 Q104, QlO5, Q106, Q114, Q204 Q205 Q206 Q214

1.5K ohm 1 watt 10%

3497

Transistors PN4250A
2N3859A selected

3786 2961

4107, Q207 Q108, Q208 QlO9, Q 2 0 9 QllO, Q 2 1 0 Q112, Q212

2N4125 selected M PSA06 M PSA56 2N6175

3625 3528 3954 3501

Diodes
DlOl, D 2 0 1 D102, 0202 D106. D 2 0 6 D103, D203 D104, 0204 D105, D205 D7, D8

1N4148

3181

1 N270 1 N4003 lN961B, 1OV z e n e r

3447 2851 3549

. Schematic Designation

PARTS LIST, D-60 Page 5 Crown Part # Other Information

Description 3" foam tape

1152 2019 4039 4071 2176 1823 3163 1889 3502 1678 2500 3492 1056 2857 3494 3291 4152 4246 4251 4252 3776 1152 3775 3834 4076 4075 4193 3891 4085 1904 41166 9590-s 2018 1751

Mounts Tl to front panel Mount on bottom back edge of FP channel Mounts outputs Mounts outputs Mounts outputs Mounts outputs Mounts outputs Mounts outputs

6-32 captive nut Anodized TO-3 insulator TO-3 insulator 6-32 x ½ BHP screw #6 internal star washer #6 solder lug 6-32 hex nut Feed-through terminals C21 I1 SW1 R31 R33 R201 R128, R228 R130, R230 Q111, Q211 4113, Q213 Tl 5MF 70V Neon lamp, NE2H D-60 power rotary switch
27K ohm ½ watt 10%

Mounts on terminal strip Mounts on terminal strip Mounts from gnd lug at input pot to main board Input level control with nut Mount on solder lugs attached to outputs Output transistors on bottom of FP channel Starts SN 14467 Mounts transformer Mounts transformer

2.7 ohm ½ watt 10% 25K ohm audio taper pot' .l ohm 5 watt 10% Wire 2N3055 selected, Motorola D-60 transformer, 10403-P2 Nylon transformer mount 8-32 x g RHP screw Fuseblock Double-sided foam tape 2.5A 3AG fuse Fuse Caution label Control knob, A-l Control knob, A D-60 serial number label *2A 120 VAC* label 13/" end bars 6-32 x 3/ SCP screw D-60 bottom cover O-60 bottom cover 8-32 captive nuts

Used to mount fuseblock Internal fuse For input pots RlOl, R201 For power switch SW 1

Mounts end bars With 2, 8-32 captive nuts Without the captive nuts Install on bottom cover

C123, C223 Cl25

.01 MF Ceramic disc