Text preview for : disassy.pdf part of Nokia 7110 Nokia 7110 Service Manual
Back to : 7110.rar | Home
PAMS Technical Documentation NSE5 Series Transceivers
Disassembly Instructions
Issue 1 07/99
NSE5 Disassembly Instructions
PAMS Technical Documentation
[This page intentionally left blank]
Page 2
Issue 1 07/99
PAMS Technical Documentation
NSE5 Disassembly Instructions
1.Remove the Battery
2. Remove Dust Cap
3. Remove the Screws (4x)
. Lift off BCover
note: snap fitting
5. Pull out Antenna
note: snap fitting
Issue 1 07/99
Page 3
NSE5 Disassembly Instructions
PAMS Technical Documentation
6. Remove the Screws (2x)
7. Lift off the PCB
8. Remove the Slide Sensor Switch
9. Pull out the Slide until the End Stop
Page 4
Issue 1 07/99
PAMS Technical Documentation
NSE5 Disassembly Instructions
10. Use a pair of Tweezers to push the Slide Stopper Spring in the direction indicated.
11. Simulateously with step 10: Pull out the Slide past the End Stop
! note: Pull out straight !
Handling the Slide Assembly:
! DO NOT handle the Slide like this ! ALWAYS handle the slide like this.
The Metal Slide is bent very easily when it is not protected by the phone. Avoid bending of the Plungers at all times.
Issue 1 07/99
Page 5
NSE5 Disassembly Instructions
PAMS Technical Documentation
12. Bend open one side of the (plastic) Slide Cover and take out the Metal Slide
! DO NOT !
Hold the Metal Slide like this.
The Metal Slide is bent very easily when it is not protected by the phone. Avoid bending of the Plungers at all times.
ALWAYS
Handle the Metal Slide like this.
The Metal Slide can be held by the Targa Bow or by one of the Plungers.
Fitting a Metal Slide onto a Slide Cover:
Push the Metal Slide onto the snap on one side of the Slide Cover. Page 6
Push down the other side, but do not hit the middle snap.
Push the Metal Slide onto the snap on the opposite side. A click should be noticed.
Issue 1 07/99
PAMS Technical Documentation
NSE5 Disassembly Instructions
13. Remove the Display Assembly
14. Remove the Keymat Module
15. Remove the Speaker and the Roller Key
Issue 1 07/99
Page 7
NSE5 Disassembly Instructions
PAMS Technical Documentation
16. ! Assemble the whole phone before fitting the Slide Assembly ! The remaining assembly is done in the reverse order of the disassembly.
Note Torque for screws 0.2Nm
17. Position the right hand Plunger onto the start of the track and on the Microphone Connector, as shown
18. Position the left hand Plungers onto the start of the track and push the Slide Assembly into the phone. ! Push the Slide Assembly straight into the phone to avoid bending of the Plungers !
Page 8
Issue 1 07/99