Text preview for : Repairing-USB-Ports-2093.pdf part of apple Repairing-USB-Ports-2093 apple Apple Studio Display M2454 Repairing-USB-Ports-2093.pdf



Back to : Repairing-USB-Ports-2093. | Home

Repairing Apple Studio Display M2454 USB Ports




Repairing Apple Studio Display M2454 USB Ports
Tools used in this guide
2mm Hex Screwdriver
Phillips #2 Screwdriver



Step 1 - USB Ports
The USB ports are located on the back side of the
monitor, below the plastic cover and metallic panel; on
the lower left hand side.
The first step is to remove the plastic cover panel.
To do so, remove the three 2mm hex screws on the
monitor's stand, as well as the four 2mm hex screws
located on the four corners of the back plastic cover
panel.
After removing the mentioned screws, it is
possible to take off the panels and began
examining the inner components. Make sure
main cable i pulled through plastic port.
For additional help removing the back panel, refer to
the repair guide for the LCD Main Board.


Step 2
Remove the three screws holding metal plate, one on
the top in the middle, and two at the bottom by the main
cable.
Push the metal plate towards bottom of the monitor to
release it from clips and remove.
After popping off (removing) metal plate, you can now
see all inner components, where the USB connector is
on left side.