| Make | Model | Problem | Solution | Date |
| | | |
| Found: 140
|
| Alba | CTV12 | No sound or raster - HT & display Ok. | D/J T201 ( looks Ok ) , Q208 o/c. | 14-09-04 |
| Alba | CTV12 | No sound/pic - HT normal | Q208 12v reg tr o/c - TIP 41 works ok | 14-09-04 |
| Alba | CTV12 | When removing back cover. | Check for screw inside rear foot ( underside ) | 14-09-04 |
| Alba | CTV14 | Dead. | Faulty mains transformer | 14-09-04 |
| Alba | CTV14 | Dead. | BR401 s/c. | 14-09-04 |
| Alba | CTV14 | Distorted sound. | Break in print to C206. | 14-09-04 |
| Alba | CTV14 | Frame collapse - no sound | R425 ( 6.8ohm ) O/C , D410 s/c | 14-09-04 |
| Alba | CTV14 | Frame collapse. | D410 s/c , R425 ( 6.8R ) o/c. | 14-09-04 |
| Alba | CTV14 | No sound. | ( 1 ) IC201 ( TBA820M ) , ( 2 ) ICMN1220. | 14-09-04 |
| Alba | CTV14 | No tuning | Q101 s/c | 14-09-04 |
|
|
| Alba | CTV14 | Only memorises enen channel numbers. | IC MN1220. | 14-09-04 |
| Alba | CTV14R | Field bounce | R317 10k 2W dry ( near line hold preset ) | 14-09-04 |
| Alba | CTV14R | If VOL up used shows row dots as if sound at min | Replace IC601 MN6030 | 14-09-04 |
| Alba | CTV14RS | Frame collapse - no sound. | D410 s/c , R425 ( 6.8R ) o/c. | 14-09-04 |
| Alba | CTV14RS | No sound & field coll | R425 6R8 o/c, D410 s/c (12v supply from lop) | 14-09-04 |
| Alba | CTV14RS | Various inc no tuning, sound, dead etc | Cracks in print on front panel | 14-09-04 |
| Alba | CTV14RS/55 | Shows row of dots when vol adj | IC601 MN6030 memory chip faulty | 14-09-04 |
| Alba | CTV2 | Int trip off & shut down | Dry joint D16 (series with a res proud of board) | 14-09-04 |
| Alba | CTV2 | SWITCHES OFF OR TRIPS AFTER 3mins | R69 OR DRY ON D16 - SITS OFF PCB IN SERIES WITH RESISTOR | 14-09-04 |
| Alba | CTV3359 | No pic - sound ok | Loss of line drive - Q601 BD679A reg; print flash over between base Q601 & o/p scan coil skt | 14-09-04 |
| Alba | CTV3400 | Field foldover at top when cold - HT low at 96v (115v) | Q506 o/c | 14-09-04 |
| Alba | CTV3408 | Dead | RP4 o/c in PSU 330K | 14-09-04 |
| Alba | CTV3409 | Dead fuse ok Q801 s/c | Replace Q801 BUZ77, R809 0R47 ?w fusible, R805 330k 1W | 14-09-04 |
| Alba | CTV3409 11AK20S | LED stays green (pic ok) | Q803 BC547 st/by sw tr leaky | 14-09-04 |
| Alba | CTV3458 | Dead | RP4 330k o/c | 14-09-04 |
| Alba | CTV3458 | Dead - BUZ90 chopper s/c | D5 FR144 in snubber network s/c - also replace R4 & 5 & TDA4605 | 14-09-04 |
| Alba | CTV3458 | Dead with mains fuse blown | C8 1nF 1kv leaky | 14-09-04 |
| Alba | CTV3458 | Field collapsed to 1" | R25 12k o/c - feed to 33v supply | 14-09-04 |
| Alba | CTV3459 | Int Field collapse with it turning off | Blanket resolder field stages even if they look ok | 14-09-04 |
| Alba | CTV4800 | No sound | Q201 2SC2703 faulty, TDA1904 audio chip faulty | 14-09-04 |