Sony MDX-C6400R free download

File name sony_MDX-C6400R_service_manual.pdf

MDX-C6400R/C6500R/C6500RX SERVICE MANUAL Ver 1.2 2001.12 AEP Model MDX-C6400R/C6500R/C6500RX UK Model MDX-C6500R/C6500RX Photo: MDX-C6500R Model Name Using Similar Mechanism Base Mechanism Type Optical Pick-up Name NEW MG-164NZ-138 KMS-241C SPECIFICATIONS MD player section Signal-to-noise ratio Frequency response Wow and flutter 90 dB 10 ­ 20,000 Hz Below measurable limit General Outputs Audio outputs*1 Power aerial relay control lead Power amplifier control lead Telephone ATT control lead*2 Bass ±9 dB at 100 Hz Treble ±9 dB at 10 kHz 12 V DC car battery (negative ground) Approx. 178 Ч 50 Ч 183 mm (w/h/d) Approx. 182 Ч 53 Ч 162 mm (w/h/d) Approx. 1.2 kg Parts for installation and connections (1 set) Front panel case (1) Tuner section FM Tuning range Aerial terminal Intermediate frequency Usable sensitivity Selectivity Signal-to-noise ratio 87.5 ­ 108.0 MHz External aerial connector 10.7 MHz/450 kHz 8 dBf 75 dB at 400 kHz 66 dB (stereo), 72 dB (mono) Harmonic distortion at 1 kHz 0.6 % (stereo), 0.3 % (mono) Separation 35 dB at 1 kHz Frequency response 30 ­ 15,000 Hz Tone controls Power requirements Dimensions Mounting dimensions Mass Supplied accessories MW/LW Tuning range Aerial terminal Intermediate frequency Sensitivity MW: 531 ­ 1,602 kHz LW: 153 ­ 279 kHz External aerial connector 10.7 MHz/450 kHz MW: 30 µV LW: 40 µV *1 Equipped with front and rear outputs: MDX-C6500RX/C6500R only Equipped with rear outputs: MDX-C6400R *2 MDX-C6500RX/C6500R only U.S. and foreign patents licensed from Dolby laboratories Licensing Corporation. Design and specifications are subject to change without notice. Power amplifier section Outputs Speaker outputs (sure seal connectors) Speaker impedance 4 ­ 8 ohms Maximum power output 50 W Ч 4 (at 4 ohms) FM/MW/LW MINIDISC PLAYER 9-870-051-13 2001L0500-1 C 2001.12 Sony Corporation e Vehicle Company Published by Sony Engineering Corporation TABLE OF CONTENTS 1. GENERAL Location of controls ... 3 Installation ... 4 Connections ... 5 NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK OR BASE UNIT The laser diode in the optical pick-up block may suffer electrostatic break-down because of the potential difference generated by the charged electrostatic load, etc. on clothing and the human body. During repair, pay attention to electrostatic break-down and also use the procedure in the printed matter which is included in the repair parts. The flexible board is easily damaged and should be handled with care. NOTES ON LASER DIODE EMISSION CHECK Never look into the laser diode emission from right avove when checking it for adustment. It is feared that you will lose your sight. NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK (KMS-241C/J1NP). The laser diode in the optical pick-up block may suffer electrostatic break-down easily. When handling it