| Make | Model | Problem | Solution | Date |
| | | |
| Found: 509
|
| ITT | Digi 3 | The picture looks cloudy. | Frame IC TDA2170 , plus change 100uf C402 or C602 by it. | 14-09-04 |
| ITT | Digi 3 | There were three alternative fault symptoms with t | A cracked joint at one of the Primary winding pins of the standby transformer produced the no go problems. The sync problems | 14-09-04 |
| ITT | Digi-3 | Blank raster - no sound. | IC MDA2061 ( Sel3776 52 07 ) on front unit. | 14-09-04 |
| ITT | Digi-3 | Colour - flickering. | IC650 ( VCU2100 ) | 14-09-04 |
| ITT | Digi-3 | Dead - blowing fuses. | Frame IC s/c IC401 ( TDA217p ) | 14-09-04 |
| ITT | Digi-3 | Dead. | Replace T716 , T711 , T726. | 14-09-04 |
| ITT | Digi-3 | Dead. | Replace D795 ( MR856 ) s/c. | 14-09-04 |
| ITT | Digi-3 | Grey scale flickering. | Replace IC620 ( DPU2540 ) on digital module. | 14-09-04 |
| ITT | Digi-3 | No picture or sound - LED not working. | DJ on IC771. | 14-09-04 |
| ITT | Digi-3 | No raster - EHT ok. | R534 ( 560k ) o/c , VCU2100A chip. | 14-09-04 |
|
|
| ITT | Digi-3 | No remote functions - picture jumpin | Replace IC640 ( TPU2732 ) on digital module. | 14-09-04 |
| ITT | Digi-3 | No sound | Replace IC02 ( MOA2061 ) on remote panel. | 14-09-04 |
| ITT | Digi-3 | No sound. | IC MDA2061 ( Sel3776 52 07 ) on front unit. | 14-09-04 |
| ITT | Digi-3 | No text or remote functions - picture jumping | Replace IC640 ( TPU2732 ) on digital module. | 14-09-04 |
| ITT | Digi-3 | Picture jumping - no text or remote func. | Replace IC640 ( TPU2732 ) on digital module. | 14-09-04 |
| ITT | Digi-3 | Sound - mutes using stanby but set stays on. | Relay sticking. | 14-09-04 |
| ITT | Digi-3 | Sound reduce part down then thud to low sound | IC MDA2061 ( Sel3776 52 07 ) on front unit | 14-09-04 |
| ITT | Digi-3 | Spook on picture. | IC1402 E-prom sel 3776 5207. | 14-09-04 |
| ITT | Digi-3 | Teletext - shimmering - picture ok. | Replace IC640 ( CPU2732 ) on digital board. | 14-09-04 |
| ITT | PICO S3 | DEAD IF SCAN COILS DISCONNECTED TRIES TO RUN | WIDTH CCT ON SCAN COILS SC | 14-09-04 |
| ITT | PICO S3 | STBY LED FLICKERS BUT DEAD . PIN 4 LOPTX REMOVED P | LOPTX US | 14-09-04 |
| ITT | 110 Digi-3 | Dead - blowing line transistor. | C714 int o/c. | 14-09-04 |
| ITT | 1611 | Dead - int. | Dirty contacts on on/off switch relay. | 14-09-04 |
| ITT | 1660 | No colour. | C721 ( 100u f ) o/c. | 14-09-04 |
| ITT | 2705 | Tripping. | BU208. | 14-09-04 |
| ITT | 30 | Focus - control aching. | Change CRT base not just the control - it will do again. | 14-09-04 |
| ITT | 3425 80R | Standby - going into standby. | IC1404 5 volt Reg. | 14-09-04 |
| ITT | 3426 Comp B | No colour. | C891 s/c , IC800. | 14-09-04 |
| ITT | 3447 Digi-3 | No picture - sound & EHT ok. | D771 s/c , R771 o/c. | 14-09-04 |
| ITT | 3447 Digi-3 | No sound & blank raster - stuck in AV mode. | IC1401 pin 25 latched high. | 14-09-04 |