| Make | Model | Problem | Solution | Date |
| | | |
| Found: 509
|
| ITT | Monoprint B | Slow startup. | C704 ( 47u f ) , C701 ( 4.7u f ) may check Ok. | 14-09-04 |
| ITT | Monoprint B | St/by only | HT at chopper Tr - Replace C701 4µ7 400v o/c; BU508A LOP Tr leaky | 14-09-04 |
| ITT | Monoprint B | St/by only | C715 | 14-09-04 |
| ITT | Monoprint B | St/by only with EHT present | C722 | 14-09-04 |
| ITT | Monoprint B | Txt inoperative - indicator works | DPU2540 chip on txt panel | 14-09-04 |
| ITT | MP37H | No sound via tuner - ok via scart | Surf mount Tr VA02 BC847 leaky b-e - pulled down pin 1 of TDA8362 audio de-emphasis | 14-09-04 |
| ITT | Pico | Dead - PSU not operating | ZPY120 120v over volts zener leaky | 14-09-04 |
| ITT | Pico | Will not startup - LTB loaded. | Disconnect scan coils if sounds better then LOPTX. | 14-09-04 |
| ITT | Pico 1 | Dark pic | TDA3561 u/s | 14-09-04 |
| ITT | PICO 1 | PICTURE DARK ( NOT A1 SUPPLY ) | TDA3561 | 14-09-04 |
|
|
| ITT | Pico 1A | Dead - with rapid ticking | No HT - D658 120v zener leaky | 14-09-04 |
| ITT | Pico 1A | Tuning - will not tune in. | R1154 ( 2.2k ) o/c , D1151 ( reads ok ) | 14-09-04 |
| ITT | Pico S | Bad hum bar & no sound | Replace 4 x 1N4007 mains rects | 14-09-04 |
| ITT | Pico S | Blank raster with line tearing - sound int | C524 10µ | 14-09-04 |
| ITT | Pico S | dead | 2A fuse on front panel o/c; degauss therm caused it | 14-09-04 |
| ITT | Pico S | Dead. | Check small LT transformer for o/c. | 14-09-04 |
| ITT | Pico S | Display shows "88" | SAA1292 chip faulty - caused by dry joints esp on C10 1000µ | 14-09-04 |
| ITT | Pico S | Int dead when heated | 115v HT still present; dry joints LOP tr | 14-09-04 |
| ITT | Pico S | Misty pic - poor col with red flaring | Earthing ring on crt base shorting to cathodes | 14-09-04 |
| ITT | Pico S | No sound | R1075 3R3 safety res o/c; C229 220µ s/c | 14-09-04 |
| ITT | Pico S | Pulling/bouncing/int loss of sound | C212 10µ 50v in CMR800 (top of can) | 14-09-04 |
| ITT | Pico S | St/by only | relay clicks at sw on but no HT to LOP Tr; C701 10µ 350v faulty | 14-09-04 |
| ITT | Pico S2 | Dead - no relay click at switch on. | Standby mains transformer primary winding o/c. | 14-09-04 |
| ITT | Pico S2 | Dead - no relay click or display | Mains st/by tfmr o/c pri | 14-09-04 |
| ITT | Pico S3 | Dead - life restored if scan coils dis'd | Width control coil on scan coils has shorted turns | 14-09-04 |
| ITT | Pico S3 | Dead apart from brief led flicker at sw on | LOPTx | 14-09-04 |
| ITT | SP71D1 | Dead with S2000AF lop tr s/c | failed aft replacement - CK51 8n7 1.6kv faulty | 14-09-04 |
| ITT | SP71D1 | line driver tr VK22 blows few mins aft sw on | CK22 2µ2 100v | 14-09-04 |
| ITT | ST28TX | No sound/blank raster - no R/C & corrupt display | reset line to micro IC701 stuck at 4v. CCU SEL06 & MDA2061 leaky from reset pins to chassis. No sound caused by D701 1N4148 in mute line leaky. All caused by dry joints on reg chassis connection | 14-09-04 |
| ITT | ST28TXD2 S4SQ | Dead - chopper tr BU908 s/c | Change elects & TEA2165 in psu | 14-09-04 |