| Make | Model | Problem | Solution | Date |
| | | |
| Found: 659
|
| Toshiba | 2505DBT/ 2805DBT | VERY QUIET TICKING FROM RH SUOUND SPEAKER WHICH | REMOVE R610 AND JUMPER LINK J109 | 14-09-04 |
| Toshiba | 2507DB | Focus slightly out & int brightness | CRT faulty | 14-09-04 |
| Toshiba | 2512 | No st/by function | Q845 2SC2023, Q843 & CK842 | 14-09-04 |
| Toshiba | 2512 -252 | BLACK FLASHING LINES RUNNING UP THE SCREEN WORSE W | ICV01 TA8777N AV SWITCHING IC | 14-09-04 |
| Toshiba | 2512DB | Dead | Replaced TDA4601 and SE140N | 14-09-04 |
| Toshiba | 2512DB | EW faulty | Check all elects on stand up EW panel | 14-09-04 |
| Toshiba | 2512DB | FIELD JITTER , PIC BREATHING | Q833 ( S1854 - Toshiba A6907751 ) | 14-09-04 |
| Toshiba | 2512DB | in stby after LOPTx and LOPTr 2SC2023 replaced | Q843 2SA1321, Q842 2SC2230 | 14-09-04 |
| Toshiba | 2512DB | Int crackling/static noises fro rh chan in st/by | Resold joints in audio o/p chip area | 14-09-04 |
| Toshiba | 2512DB | lack of width & cogging from cold | C424 4µ7 100v on sub panel at front rh of chassis | 14-09-04 |
|
|
| Toshiba | 2512DB | Lack of width. | R425 o/c , loading coil L423 ( TX100 EW PCB ) width , EW adj via H/set | 14-09-04 |
| Toshiba | 2512DB | LOW WIDTH + EW FAULT R425 OC | L423 SHORT TURNS | 14-09-04 |
| Toshiba | 2512DB | No st/by, small raster after LOPTx replacement | Q845 st/by sw tr 2SC2023 - BUT12A used in lieu | 14-09-04 |
| Toshiba | 2512DB | Non lin field | Caps (2µ2 & 220µ) in screening can on small pcb back RHS of main pcb | 14-09-04 |
| Toshiba | 2512DB | PSU trips one minute after switch one, could be int or random | ground pin 52 of IC501, ref Toshiba technical | 14-09-04 |
| Toshiba | 2512DB | Shrunken and non-linear frame | C372 (2u2F 50v), C374 (220uF 16v), C372 (2u2F 50v) which are all mounted under a screening can on a sub panel at the front right (as seen from the rear). Also C317 (2u2F 50v) positioned under the overhang of the sub panel on the main board. | 14-09-04 |
| Toshiba | 2512DB | STATIC DISCHARGE FROM SPEAKER GRILLS | USE STATKIT TO DIRECTLY CONNECT GRILLS TO CHASSIS ( SUPERCEDES JULY BULLETIN RE FITTING NEW CABINET ) | 14-09-04 |
| Toshiba | 2512DB | STUCK IN STBY IF PIN 64 ICA01 OK AT 5v CHECK PIN 3 | REPLACE IC805 Pt No23318232 | 14-09-04 |
| Toshiba | 2512DB | WONT GO TO SBY | Q845 ( 2SC2033 - Toshiba 23314246 ) | 14-09-04 |
| Toshiba | 2512DB 2812DB C91SB | Poor width , corrugated effect on side of picture . | C424 4u7 PtNo24676479 | 14-09-04 |
| Toshiba | 2512DBT | Field - lack of height with bottom compressed | C372 2µ2 under screening can on DPC board | 14-09-04 |
| Toshiba | 2512DBT | Height reduced & E-W bowing | C372 2µ2 & C374 220µ in DPC module | 14-09-04 |
| Toshiba | 2512DBT | Lack of height & wobbly outlines | Elects (esp brown ones) in hor driver module | 14-09-04 |
| Toshiba | 2512DBT | POOR NICAM WITH WHISTLE CRACKING/POPPING | REDRESS SCAN COIL LEADS AND DIGITAL DATA LEADS | 14-09-04 |
| Toshiba | 2512DBT | Service mode access | Press the "F" button & video input button together on R/C. Enter "1048" R/C; "M" appears at the top right hand corner of screen. Hold "F" button & press picture menu button - Menu item up. Hold the "F" button and press the sound menu button - Menu item down
Adjust using the volume "+" and "-" buttons - Go to standby to store and exit. | 14-09-04 |
| Toshiba | 2512DBT | St/by cannot be initiated | s/c tr in psu | 14-09-04 |
| Toshiba | 2512DBT | Whistling , crackling , popping poor sound. | Redress scan coil , nicam signal leads. | 14-09-04 |
| Toshiba | 2512DBT | Won't go into st/by | 2SC2032 (not 2SC2033) | 14-09-04 |
| Toshiba | 2527DB | CRACKLE ON NICAM , FM. AND EXT SOURCES | ICG07 AUDIO PROCESSOR ( TA8776N ) BACK TERMINAL BOARD | 14-09-04 |
| Toshiba | 2527DB | DEAD , POWER AND TIMER LEDS FLASHING HT 40v AND VAR | Q828 2SC2230A-Y | 14-09-04 |