Make | Model | Problem | Solution | Date |
| | | |
Found: 1049
|
Panasonic | Euro 7 TX32PG30 | St/by only | Reset line volts going into U1 pcb stuck halfway - being loaded by faulty sm filter LC1118 in reset line | 14-09-04 |
Panasonic | Euro 8F | Corrugated verts & col hor bands | Z950 fuse had increased in value to 0R3 | 14-09-04 |
Panasonic | Euro 8F | Dead | Z950 fuse o/c, Q901 chopper tr s/c, D909 zener s/c & R901 o/c | 14-09-04 |
Panasonic | Euro1 TX25A3 | Dead - blows mains fuse at sw on | Replace switch mode transformer (T639) which had shorted primary windings. P No. (TLP8E1000). | 14-09-04 |
Panasonic | Euro2 | line sync unstable | IC1202 note model suffix for chip types | 14-09-04 |
Panasonic | Euro2 | top half of pic blacked out | IC1203 note model suffix for chip types | 14-09-04 |
Panasonic | Euro2 TX21AD2/M | Relay clicks on & off in regular fashion | C807 100µ 25v hi esr | 14-09-04 |
Panasonic | Euro2 TX25MD1 | Dead but with psu running | No supply to line dr as F851 1.25A o/c. 4R short across supply caused by LOPTx | 14-09-04 |
Panasonic | EURO2L TX21MD1 | coloured lines on top | D454 (ERA1502V3) D456 (MA2160BLFS) IN FRAME O/P | 14-09-04 |
Panasonic | EURO2L TX21MD1 | flyback lines on the top | C456 220UF 50V NEAR FRAME IC | 14-09-04 |
|
Panasonic | EURO2L TX21MD1 | OK from cold, after 1-2 hours pic goes off, set trips then goes to stby | NICAM IC2101 MSP3410 ON TUNER/IF MODULE | 14-09-04 |
Panasonic | EURO2L TX21MD1 | varying height | DJ ON R464 IN THE FRAME AREA | 14-09-04 |
Panasonic | EURO2L TX25MD1 | black diagonal lines on screen, loss of colour, then pic collapses into middle of screen | DJ on Xtal X601 under screening can next to VDP IC | 14-09-04 |
Panasonic | EURO2L TX25MD1 | blows mains fuse | PTC R808 (232266296319) | 14-09-04 |
Panasonic | EURO2L TX25MD1 | flyback lines on the top | D456 MA2160B s/c | 14-09-04 |
Panasonic | EURO2L TX25MD1 | green speckles on screen (RF and SCART) | replace IC601 VDP3108-29 | 14-09-04 |
Panasonic | EURO2L TX25MD1 | RGB lines at top of picture | D454 (ERA1502V3) D456 (MA2160BLFS) IN FRAME O/P | 14-09-04 |
Panasonic | EURO2L TX25MD1 | screeching noise | repace IC2101 MSP3410 (can use part no.10372340 for Ferguson) | 14-09-04 |
Panasonic | EURO2L TX25MD1 | streaks of colour on pic | replace IC601 VDP3108APPA1 | 14-09-04 |
Panasonic | EURO2L TX28LD1 | distorted, displaced chroma | IC601 VDP3108APPA1 | 14-09-04 |
Panasonic | EURO2L TX28LD1 | pic smearing on highlights, going green and magenta at either side of highlight | replace IC601 VDP3108-29 and set-up video levels and A1 voltage | 14-09-04 |
Panasonic | EURO2L TX28LD1 | severe overscan, pic appears upside down | wrong type of IC451 used, use from Panasonic | 14-09-04 |
Panasonic | EURO2L TX28LD1 | stuck in stby | R558 120k o/c in beam limiter circuit off LOPTx | 14-09-04 |
Panasonic | EURO2M TX25MD3 | no pic, sound OK | no supply to line driver Q503, replace R507 3.3R safety (ERQ14AJW3R3) | 14-09-04 |
Panasonic | Euro2M TX25MD3 | Pic gradually fades away, returns when set sw off & on again - sound unaffected | IC601 Vid proc chip VDP3108-APP1 | 14-09-04 |
Panasonic | EURO2M TX25MD3 | when watching VCR, ghost image of another pic moving across screen, also colour bands. | customer using fully wired SCARD lead, thus TV's tuner output is fed back to VCR what modulates video playback picture. Remove unused leads in SCART cable or use non-fully wired SCART cable. | 14-09-04 |
Panasonic | EURO2M TX28MD3 | blows mains fuse every 2-3 months | replace PTC 232266296319, also mains lead connector may come loose and arc (part no TSX8E0017) | 14-09-04 |
Panasonic | EURO2S TX25AD1DP | AFTER REPLACING EEPROM SET COMES ON TO CHANNEL 0 AND 'NORMAL' SETTINGS WILL NOT MEMORISE | PRESS TOGETHER 'STATUS' ON R/C AND 'FUNCTION' AT FRONT OF TV. THE SET WILL RUN 'SELF-TEST'. SWITCH THE SET OFF, THEN BACK ON AND RE-TUNE | 14-09-04 |
Panasonic | EURO2S TX25AD1DP | dead, tripping | Q651 O/C (PART NO. TFD312S0F632) | 14-09-04 |
Panasonic | EURO2S TX25AD1DP | E/W fault | Q593 BC847B S/C | 14-09-04 |