Make | Model | Problem | Solution | Date |
| | | |
Found: 315
|
Sanyo | CB5156 | Thin dark vertical line on the left side of the picture | R433 DJ, located next to the SCART socket | 14-09-04 |
Sanyo | CB5159 C21EF35NB | Dead | IV451 LA7832 FOP chip s/c, R364 4R7 ?w fusible o/c, C362 22µ 250v 180v smoother s/c, D351 dry joint | 14-09-04 |
Sanyo | CB5159 C21EF35NB | No sound | Q2961/2962 2SC812L6 sm on nicam pcb both faulty- used BC846B in lieu, TDA7263 AF o/p chip u/s | 14-09-04 |
Sanyo | CB5159 C21EF35NB | No Txt | No 5v (REF+) pin 6 IC1001 Txt dec chip SAA5281P/E- D1001 5v1 zener leaky | 14-09-04 |
Sanyo | CB5949 EB2 | Int white flashes across screen removing vid signal | 27Mhz Xtal on Txt pcb | 14-09-04 |
Sanyo | CB5957 Mk2 | Int low gain tuner | Dry joints tuner screening can | 14-09-04 |
Sanyo | CB5959 | STUCK IN STANDBY | CHECK C422 FOR S/C | 14-09-04 |
Sanyo | CB5959 EB2A25 | Int startup with motorboating from spkrs then no sound/vol OSD | TDA7263M audio o/p IC | 14-09-04 |
Sanyo | CBP1443 | not tuning in, no functions | Eeprom IC790 (4092477702) | 14-09-04 |
Sanyo | CBP2145 | Bright pic with fback lines | R478 o/c | 14-09-04 |
|
Sanyo | CBP2145 | Interference lines on picture | IC361(LM7812 | 14-09-04 |
Sanyo | CBP2145 | No sync | D1010 5v zener | 14-09-04 |
Sanyo | CBP2145 | One colour dropping out. | Resolder transistors & edge connector on CRT base. | 14-09-04 |
SANYO | CBP2145 | PATTERN ON SCREEN AFTER 1 HR | REPLACE C364 AND C398 100MFD25V | 14-09-04 |
Sanyo | CBP2145 | Poor pic until heated | C364/395/397all,[100mf 16v] C396,[470mf,16v] C398,10mf,16v] | 14-09-04 |
Sanyo | CBP2145 E2 | Arcing noise and flashing pic for first 10 mins or line tearing on high brightness scenes | C364 100µ in 12v supply | 14-09-04 |
Sanyo | CBP2145 E2 | Field - partial collapse, no sound & shaky pic | C346 & C398 100µ 25v in psu | 14-09-04 |
Sanyo | CBP2145 E2 | Field collapse | Dry joints FOP stage & check 10µ 25v caps in this stage | 14-09-04 |
Sanyo | CBP2145 E2 | LINE PULLING + BUZZING FROM COLD | C364 100uF 16v | 14-09-04 |
Sanyo | CBP2145 E2 | LOSS OF SIGNALS | L391 5v SUPPLY TO TUNER. CAN REPAIR THEMSELVES AS SET WARMS UP. | 14-09-04 |
Sanyo | CBP2145 E2 | No signals | Check L391 coil which supplies 5v to tuner - can be int | 14-09-04 |
Sanyo | CBP2145 E2 | No sigs at sw on - ok when heated | C397 & C364 10µ 16v | 14-09-04 |
Sanyo | CBP2145 E2 | No sigs for first 10 mins & only chans 3 & 4 selected | Ripple on 5v supply - C395 100µ 16v | 14-09-04 |
Sanyo | CBP2145 E2 | No start up | D331 opto had slight leak | 14-09-04 |
Sanyo | CBP2145 E2 | Picture break up & bad twitching. | Replace C364 ( 10uf , 16V ) | 14-09-04 |
Sanyo | CBP2145 E2 | POOR PICTURE WHEN BRIGHTNESS TURNED UP | C364 100uF 16v OC | 14-09-04 |
Sanyo | CBP2145 E2 | Signals noisy with lack of height | C397 100µ 16v | 14-09-04 |
Sanyo | CBP2145 E2 | TUNER SEEMS LOW GAIN FOR 10mins | C397 364 10uF 16v | 14-09-04 |
Sanyo | CBP2145 E2-B21 | FIELD JITTER AND OR PART FIELD COLLAPSE | C364 C398 100uF 25v | 14-09-04 |
Sanyo | CBP2146 | Negative picture on small insert. | QC0905A/3052v 5v reg. | 14-09-04 |