| Make | Model | Problem | Solution | Date |
| | | |
| Found: 315
|
| Sanyo | CTP3106 80P | No colour. | C202 , C204. | 14-09-04 |
| Sanyo | CTP3131 | BLANK RASTER WITH FLYBACK LINES | CHECK R464 ( 100ohms ) 85v SUPPLY TO RGB O.P. | 14-09-04 |
| Sanyo | CTP3131 | SEVERE RASTER DISTORTION , FAST ROLLING | MAINS SMOOTHING O.C. 100mfd 400v | 14-09-04 |
| Sanyo | CTP5101 | No picture - sound ok. | R617 ( 330k ) o/c. | 14-09-04 |
| Sanyo | CTP5103 | East west - bowing out. | Change C451 ( 330u F ) & try C455 ( 330nF ) & C456 ( 180nF ) | 14-09-04 |
| Sanyo | CTP5103 | Frame reduced - 3" at centre. | C451 ( 330u f , 10v ) leaky. | 14-09-04 |
| Sanyo | CTP5103 | Frame rolling. | D201 leaky. | 14-09-04 |
| Sanyo | CTP6102 | Frame - scan creeps up as set warms up. | Q422 leaky. | 14-09-04 |
| Sanyo | CTP6114 | Set trips or will not start | Check 5V reset to microcontroller T319 primary o/c increase R319 to ( 680R ) | 14-09-04 |
| Sanyo | CTP6130 80P | Dead. | R302 ( 330k ) | 14-09-04 |
|
|
| Sanyo | CTP6132 | Dead | F301 800mA o/c; Q304 chopper tr s/c;C308 100µ was the cause | 14-09-04 |
| Sanyo | CTP6132 80P | Frame foldover at top. | C440 ( 4.7uf ) also change C447 ( 10uf ) | 14-09-04 |
| Sanyo | CTP6133 | Changes channel by itself , may be a slight hum ba | Mains capacitor | 14-09-04 |
| Sanyo | CTP6133 | Jumps/bounces and at sw on & line at top | C303 1µ stopped bouncing but line could be scan coils? | 14-09-04 |
| Sanyo | CTP6143 | Shutdown - after about 10 mins - intermittent | Focus spark gap arcing to link J105. | 14-09-04 |
| Sanyo | CTP6143/4 | Thin horizontal bars on ch above 41. | Add 0.47uf , 50v across C123. | 14-09-04 |
| Sanyo | CTP6144 | Dead | T391 o/c | 14-09-04 |
| Sanyo | CTP6144 | Dist pic & sound when cold | IC361 - 12v reg | 14-09-04 |
| Sanyo | CTP6144 | Field collapse | C435 2200µ 25v; R113 820k o/c | 14-09-04 |
| Sanyo | CTP6144 | Going off - display flashing - east west. | Dry joints on chopper transformer T301. | 14-09-04 |
| Sanyo | CTP6144 | Int dead | Dry joints T301 | 14-09-04 |
| Sanyo | CTP6144 | Int red pic | dry joints crt base | 14-09-04 |
| Sanyo | CTP6144 | Lack of height | C435 2200µ 25v | 14-09-04 |
| Sanyo | CTP6144 | No col | IC TDA3565 | 14-09-04 |
| Sanyo | CTP6144 | Set going off. | Drys on pins of chopper transformer T301. | 14-09-04 |
| Sanyo | CTP6144 | St/by only - no line drive | IC101 TDA4505 | 14-09-04 |
| Sanyo | CTP6144 | TOO BRIGHT | R478 OC | 14-09-04 |
| Sanyo | CTP6144 | Tripping - power supply | T391 ( part no PT0144 ) high resistance or o/c winding. | 14-09-04 |
| Sanyo | CTP7131 | DEAD BU208 SC . CHECK HT , IF HIGHER THAN 145v | C314 220uF 25v | 14-09-04 |
| Sanyo | CTP7132 | Field collapse | C445 ( 2 , 200uF ) | 14-09-04 |