| Make | Model | Problem | Solution | Date |
| | | |
| Found: 315
|
| Sanyo | CE28WP3 | Dead | Chopper Tr & 2SC3807 in psu s/c | 14-09-04 |
| Sanyo | CE28WP3 | Poor low contrast pic | CRT faulty (Philips) | 14-09-04 |
| Sanyo | CE28WP4 | E/W & excess height | Fit geometry mod kit pt no B10H04DOL & reset PROM values | 14-09-04 |
| Sanyo | CE28WP4 | Tuning won't stop in search & slow to tune in manually | Slight tweaking of AFC coil L171 | 14-09-04 |
| Sanyo | CE32WN4 EB6-A | Dead apart from orange LED lit | R621 120k in psu pri o/c | 14-09-04 |
| Sanyo | CE32WN5B | Dead | Replace the 2 x 120K Resistors in Power Supply | 14-09-04 |
| Sanyo | CE32WP3 | St/by only | IC051 TA8216H blown but replacement failed to cure - to disable st/y dis J616 - R1637 2R7 & D1637 replaced. When 5v supply on pin 4 Plug K31CC dis'd set starts up - traced to IC3101 JLC1562BN faulty | 14-09-04 |
| Sanyo | CE32WP3 | Trips straight off to st/by | IC501 TA8216H audio chip faulty - also R1637 2R7 5w & D1637 YG901C2-LB but still trips. IC3101 JLC1562BN on Nicam board was the cause. Disabling st/by cct by dis'ing J616 in psu helps to fault find | 14-09-04 |
| Sanyo | CE32WP3B | St/by only | 2632 BC556B in psu pri | 14-09-04 |
| Sanyo | CEP7100 | FIELD FOLDOVER | C440 4u7 250v | 14-09-04 |
|
|
| Sanyo | CEP7100 | Field foldover at top | C440 4µ7 250v | 14-09-04 |
| Sanyo | CPT 6143 / 6144 | LOW FIELD | C435 R1143 | 14-09-04 |
| Sanyo | CPT2180 | Varying Brightness with int fizzing noise | Check for D/J focus control earth tag | 14-09-04 |
| Sanyo | CPT3131 | Extreme EW bowing | If H.T. low replace C308 ( 100uF ) 400V | 14-09-04 |
| Sanyo | CPT6143 / 6144 | LOW FIELD | C435 R1143 | 14-09-04 |
| Sanyo | CPT6144 | TRIPS OR BUZZES AT SWITCH ON ONCE ON O.K. | STBY TX OC T391 | 14-09-04 |
| Sanyo | CPT7135 | Lack of width - blowing 2SD. | Emiter/Base wires round the wrong way. | 14-09-04 |
| Sanyo | CPT7135 | TRIPS | C321 10uF OC | 14-09-04 |
| Sanyo | CT7118 | East west. | D601/2 , R626 , Q752 , R764. | 14-09-04 |
| Sanyo | CTP 3131 | BLANK RASTER WITH FLYBACK LINES | CHECK R464 ( 100ohms ) 85v SUPPLY TO RGB O.P. | 14-09-04 |
| Sanyo | CTP 3131 | SEVERE RASTER DISTORTION , FAST ROLLING | MAINS SMOOTHING O.C. 100mfd 400v | 14-09-04 |
| Sanyo | CTP130/1/2 | Dead - blown or blowing line transistor. | Dry joint on heatsink support tag. | 14-09-04 |
| Sanyo | CTP132 | Top foldover | C44 4µ7; C447 10µ | 14-09-04 |
| Sanyo | CTP3101 | No lum | Q342 in blanking cct | 14-09-04 |
| Sanyo | CTP3101 | No luminance. | Q342 checks ok out of cct. | 14-09-04 |
| Sanyo | CTP3101 | No results. | Q432 ( BC107 ) | 14-09-04 |
| Sanyo | CTP3105 79P | Sync - no sync. | R403 ( 1k ) o/c , if not replace IC401 ( LA1460 ) | 14-09-04 |
| Sanyo | CTP3106 80P | Dead - 2A fuse blown. | Check C1001 ( 100u f ) , D301 , C308 ( 100u f ) | 14-09-04 |
| Sanyo | CTP3106 80P | Dead - 800Ma fuse blown. | Check Q304 , C315 , ( 1500pf ) , Q301/2/3 , D305/7. | 14-09-04 |
| Sanyo | CTP3106 80P | Dead. | No 300v at C308 , check L1001 , SW1001 , R301 , L302. | 14-09-04 |