| Make | Model | Problem | Solution | Date |
| | | |
| Found: 711
|
| Sharp | CS 59/66CS03H | dead, no green LED, only neon | audio stage s/c shorting +16V and -16V rails. Replace D305, D306, D307, D308, Q305, Q306, Q311, Q312 | 14-09-04 |
| Sharp | CS 59/66CS03H | field bounce and then field roll on text only | C604 330uF 10V | 14-09-04 |
| Sharp | CS 59/66CS03H | frame collapse | no 5V supply, replace Q707 BC337 and R643 5R6 0.5W | 14-09-04 |
| Sharp | CS 59/66CS03H | int. dead, LOPTr runs hot and blows after a few days | poor connection on scan plug on scan coil (not pushed fully to locked position) | 14-09-04 |
| Sharp | CS 59/66CS03H | no line drive, red and green LEDs on, all secondary volts Ok | R740 330k 0.25W o/c (no volts on pin 15 IC1010) | 14-09-04 |
| Sharp | CS 59/66CS03H | no pic, no sound, set tripping | R628 getting hot, 45V supply down to under 10V due to Q704 BC338 s/c (+5V standby and sound supply) | 14-09-04 |
| Sharp | CS 59/66CS03H | no response to remote or front buttons | D1101 (RHEX0545BMZZ) s/c, no supply to pin 1 IC1010 | 14-09-04 |
| Sharp | CS 59/66CS03H | no sound, pic Ok | Sound muted by Q314, Q313, Q315 not getting +40V supply from line stage, R643 5.6R o/s. These components are not market on CCT, instead refer to CCT of 51CS03H | 14-09-04 |
| Sharp | CS 59/66CS03H | no teletext | no video on pin 10 IC401 due to Q451 2SA1037 and Q901 2SC2412 leaky. | 14-09-04 |
| Sharp | CS 59/66CS03H | poor focus (looks like CRT faulty) | R618 22k gone high | 14-09-04 |
|
|
| Sharp | CS 59/66CS03H | slow start from cold, NICAM LED is on | C714 1000uF 10V 105degree | 14-09-04 |
| Sharp | CS 59/66CS03H | slow to come on | C712 220uF 25V | 14-09-04 |
| Sharp | CS 59/66CS03H | sound Ok, no pic. Flyback lines visible if A1 turned up. | R640 180R fusible s/c (RRXZ227BMZZ) | 14-09-04 |
| Sharp | CS 59/66CS03H | stuck in stby | Q704 BC338 o/s | 14-09-04 |
| Sharp | CS 59/66CS03H | trips, no pic or sound, but bright light on top of screen with random colours | Q707 BC338 o/c in "all time" 5V supply | 14-09-04 |
| Sharp | CS 59CS05H | Dead | IC201 TDA8375A IF/vid chip faulty | 14-09-04 |
| Sharp | CS 66CS-03H | Field cramp at top | C512 22µ 50v | 14-09-04 |
| Sharp | CS chassis | Accessing service mode | press vol down & ch. up when powering up then store withstandby button. | 14-09-04 |
| Sharp | CS chassis | Audio whistle | Damaged print feeding 40v to R368 | 14-09-04 |
| Sharp | CS chassis | Blank raster - no scastle pulse | Check D602 | 14-09-04 |
| Sharp | CS chassis | Blank raster & fback lines when heated | Tech Bulletin CTV970204 Feb 97 | 14-09-04 |
| Sharp | CS chassis | Dead - NICAM LED on or flashing | Check D609/610 or IC201 | 14-09-04 |
| Sharp | CS chassis | Dead - No volts at Q701 drain | Tech Bulletin CTV970201 Feb 97 | 14-09-04 |
| Sharp | CS chassis | Dead - Q701 &/or Q601 failed | Check D609, D610, D720, D718, Q702, Q703, C708, R706, R707, R720 | 14-09-04 |
| Sharp | CS chassis | Dead - reverts to st/by | Check audio o/p trs for s/c | 14-09-04 |
| Sharp | CS chassis | Dist sound | IC301 MSP3410 | 14-09-04 |
| Sharp | CS chassis | Failure of FOP stage | Tech Bulletin CTV970203 Feb 97 & check Q507/8/9 | 14-09-04 |
| Sharp | CS chassis | Field cramp | Replace D501, D502, D507, D512, C506 and C507. | 14-09-04 |
| Sharp | CS chassis | Field reliability mod | Add 1N4148 from emitter Q509 to cathode D513 (cathode to E Q509 . Pt No RH-DX0045BMZZ ) . Change R534 for 390R ( Pt No VRS-T) | 14-09-04 |
| Sharp | CS chassis | Int failure of Q601 & Q701 | Tech Bulletin CTV970805 Aug 97 | 14-09-04 |