| Make | Model | Problem | Solution | Date |
| | | |
| Found: 749
|
| Goodmans | 1430R | NO BAR DURING TUNING OR ADJUSTMENTS BUT FUNCTION WORKS | REPLACE IC602 | 14-09-04 |
| Goodmans | 1430R | No col & lack of height | R302 6k8 hi res | 14-09-04 |
| Goodmans | 1430R etc | Low gain when tuner replaced | Fit 27R res between pin 8 & 9 of IC pins adj to tuner | 14-09-04 |
| Goodmans | 1430R Onwa | St/by only | IC301 pin 21 TA8718N 9v supply missing - R302 6k8 5w o/c | 14-09-04 |
| Goodmans | 1430R/RA | Rolling/weak sync | Pin2 IC301 TA8718N should be 11v if only 9v check C328 0µ01 by sustitution | 14-09-04 |
| Goodmans | 1430RA | No pic, relay clicks & LED lights | ZD301 9v1 zener s/c | 14-09-04 |
| Goodmans | 1430RA | No start up | R302 6.8k start-up O/C caused by short in TA8718N IC. Please note this Onwa variation Uses TA8718N in IC position IC 302 not the usual AN 5601K. | 14-09-04 |
| GOODMANS | 1430RA | POWER COMES ON BUT NO PICTURE | CHECK ZD301 FOR S/C DIODBZX55B9V1 (9.1V) | 14-09-04 |
| Goodmans | 1430RA | Waving bands of interference & venetian blind effect | C311 10µ 16v o/c near IC301 TA8718 | 14-09-04 |
| Goodmans | 1430RA (Onwa) | No col, lack of height/bottom cramp HT 112v as per manual | R302 6k8 in 8v startup supply hi res | 14-09-04 |
|
|
| Goodmans | 1430RA (Onwa) | No sound no cursor on the baragraph | Don't replace the eprom! Disconnect pin 4 IC601, turn on and turn up the volume using the remote. When cursor and sound appear, resolder without turning off then hit standby on the remote to save!! | 14-09-04 |
| Goodmans | 1430RW | DEAD RELAY CLICKING | C915 LEAKY | 14-09-04 |
| Goodmans | 1430RW | Relay clicks at sw on but no +B volts | C915 ceramic cap leaky | 14-09-04 |
| Goodmans | 1430RWA | Dead - trips if on/off sw held in | C909/911 & lop tr 2SD2499 s/c (2SD1556 in lieu) | 14-09-04 |
| Goodmans | 1432 early | Poor interlace effect when VCR played | C117 2µ2 50v in IF can | 14-09-04 |
| Goodmans | 1435RS | Cogging pic | C2501 o/c | 14-09-04 |
| Goodmans | 1435RS | Dead - no st/by LED | R913 220k o/c | 14-09-04 |
| Goodmans | 1435RS | Excess height with top foldover | C2404 10nF sm leaky | 14-09-04 |
| Goodmans | 1435RS | Field collapse | R413 6k8 o/c | 14-09-04 |
| Goodmans | 1435RS | FRAME COLLAPSE | CHECK R413 6.8K FOR O/C | 14-09-04 |
| Goodmans | 1435RS | Lack of height | R335 180k hi res or o/c | 14-09-04 |
| Goodmans | 1435RS | Sound dist | R204 47R o/c | 14-09-04 |
| Goodmans | 1435RS | Sound low or int | IF Screening can s/c screened lead from audio IF to O/P - re-position | 14-09-04 |
| Goodmans | 1435RS | Sound missing | D607 1N4148 | 14-09-04 |
| Goodmans | 1435RS | Sound oscillates - varies with vol | Dry joint C143 - pin 14 IC101 | 14-09-04 |
| Goodmans | 1435RS | Volume varies | Dry joints C413 10µ 50v near speaker | 14-09-04 |
| Goodmans | 1435RS | Volume won't reduce & no mute | R642 6k8 o/c | 14-09-04 |
| Goodmans | 1435RS | Won't stop on chans during auto search & no col/drift when tuned in manual | No ident to IC802 pin 13 - R672 10k o/c near centre of pcb between IC201 & 301 | 14-09-04 |
| Goodmans | 1450T | Bright raster with fback lines | C431 10µ 250v low cap | 14-09-04 |
| Goodmans | 1450T | Dead with faint noise from psu | R404 1R 1/2w o/c | 14-09-04 |