| Make | Model | Problem | Solution | Date |
| | | |
| Found: 749
|
| Goodmans | 285DPL | Field collapse | TDA 8350Q and RK68 10R fusible both blown part no JVC*TPCE0051for chip - must use correct version of chip - cheapest at CHS | 14-09-04 |
| Goodmans | 285DPL | Field collapse | TDA8350Q, RK68 10R 1/2w & C069 220µ 35v | 14-09-04 |
| Goodmans | 285DPL | Focus out with ticking from focus unit | Dry joint RK61 5M6 | 14-09-04 |
| Goodmans | 285DPL | Lack of height | FOP chip & RK68 1R feed res | 14-09-04 |
| Goodmans | 285DPL | LACK OF WIDTH WITH E/W DISTORTION | CHECK RK62 FOR DRY JOINTS | 14-09-04 |
| Goodmans | 285DPL | LED flashes 3 times ata sw on then dead | VK71 BYW32 s/c & NS10 TDA8350Q s/c | 14-09-04 |
| Goodmans | 285DPL | LED FLASHES 3 TIMES THEN STAYS ON SET DEAD | REPLACE VK71 AND NS10 | 14-09-04 |
| Goodmans | 285DPL | No or int col | CD37 22nF 25v sm leaky - pin 6 ND10 or CD15 270pF sm pin 33 ND10 | 14-09-04 |
| Goodmans | 285DPL | No pic - blank raster if A1 advanced | CK53 0µ12 in LOP | 14-09-04 |
| Goodmans | 285DPL | No pic or OSD - Txt headings at bottom - sound ok | Flyback pulses to pin 39 ND10 jungle IC dist - CK53 120nF near LOPTx | 14-09-04 |
|
|
| Goodmans | 285DPL | No sound | NA90/40 s/c TDA2615 & RA24 1R o/c | 14-09-04 |
| Goodmans | 285DPL | NO SOUND FROM HEADPHONE SOCKET | CHECK HEADPHONE LEVEL IN SOUND MENU | 14-09-04 |
| Goodmans | 285DPL | No sound from phone skt | Check sound options menu | 14-09-04 |
| Goodmans | 285DPL | POWERS UP THEN GOES TO STANDY | VK67 ON PIN 3 OF LOPTX S/C | 14-09-04 |
| Goodmans | 285DPL | PUTTING NOISE ON STANDBY | REMOVE LINK WA21 ON DOLBY MODULE | 14-09-04 |
| Goodmans | 285DPL | Reverts to st/by at sw on | VK67 BA158 s/c ( pin 3 LOPTx) | 14-09-04 |
| Goodmans | 285DPL | Shuts down with EHT rush at sw on | LOPTx | 14-09-04 |
| Goodmans | 285DPL | Snowy pic | Check AGC volts pin 1 tuner - if < 9v sus C101 47nF sm | 14-09-04 |
| Goodmans | 285DPL | St/by only | timing constant capacitor for the standby IC is leaky. The IC is mounted on a heatsink in the middle of the board. C093 is a pair of surface mount capacitors [in parallel] connected between pins 2 and 4 of the IC. Remove these capacitors and replace them with a 220nf. | 14-09-04 |
| Goodmans | 285DPL | St/by only | C093 leaky (No reset volts to micro) | 14-09-04 |
| Goodmans | 285DPL | St/by only | FOP chip TDA8350Q, NS10 RK68 10R fusible & VK71 BY399 | 14-09-04 |
| Goodmans | 285DPL | St/by only - sec supplies ok | No line dr - VK22 Line dr Tr s/c BC337-40 | 14-09-04 |
| Goodmans | 285DPL | St/by only with LED rapid flash initially | s/c LOP stage - VK51 BY228 & VK61 BYW74 s/c | 14-09-04 |
| Goodmans | 285DPL | STUCK IN STANDBY | CHECK VK51 BY228 AND VK61 BYW74 FOR S/C | 14-09-04 |
| Goodmans | 285DPL | TICKING NOISE FROM FOCUS UNIT AND PICTURE OUT OF FOCUS | CHECK FOR DRY JOINTS ON RK61 | 14-09-04 |
| Goodmans | 285DPL | To set Personal Preference on Vis menu | Press Ideal on R/C until highlighted in menu then press Vision - PP now available | 14-09-04 |
| Goodmans | 285DPL | Trips/shuts down once or twice a day | LOPTx arcing - replace & VK51 BY228 | 14-09-04 |
| Goodmans | 285NS | CABINET RATTLE | REMOVE SPEAKER GRILLS AND FIT FELT | 14-09-04 |
| Goodmans | 285NS | CAUSING TIMER PROBLEMS WITH SOME VCR'S | REPLACE MICRO | 14-09-04 |
| Goodmans | 285NS | Dead - LOPTx s/c between LOPTr coll & ground | HR / Diemens HR7927 ?15 from Grandata Replaced TDA8351 Grandata ?2 | 14-09-04 |