| Make | Model | Problem | Solution | Date |
| | | |
| Found: 749
|
| Goodmans | Compact 10 | Dead | Field chip AN5512 | 14-09-04 |
| Goodmans | COMPACT 110 | Dead | CHECK REG , AND FIELD CHIP AN5512 Pt No. CPC*HN5652AN5512 | 14-09-04 |
| Goodmans | Compact 110 | Dead | High HT can cause havoc rendering set beyond repair - signs are bulging elects in fop stage | 14-09-04 |
| Goodmans | Compact 110 | Dead | Remove black glue, check 180k start up resistors & 47µ caps in psu | 14-09-04 |
| Goodmans | Compact 110 | Dead | Check CP22 & 30 100µ & RP04 & 05 180k. QP01 2SA1012 - use BD224C in lieu. ZP06 6v8 zener & RV01 4R7 & ICV1 TDA3653 | 14-09-04 |
| Goodmans | Compact 110 | Dead - no psu o/p | DP09 s/c, RP20 burnt up | 14-09-04 |
| Goodmans | Compact 110 | Dead - no psu operation | R5 180k o/c | 14-09-04 |
| Goodmans | Compact 110 | Dead - psu blows up | Onwa kit available | 14-09-04 |
| Goodmans | Compact 110 | Dead after ran on 24v instead of 12v | QPD1 2SB826 reg s/c, when replaced field collapse - TDA3653B fop chip & feed res burnt - used 4R7 1/4w & replace HT pot for int pic size with lines | 14-09-04 |
| Goodmans | Compact 110 | Dead -went off with a flash | burn up on pcb between CP10 & link adjacent to RP06 - RP06 39R 7w o/c, dry joints RP09 & remove black glue | 14-09-04 |
|
|
| Goodmans | Compact 110 | Field - lack of height with bottom compressed | RP05 8k2 3w metal film o/c | 14-09-04 |
| Goodmans | Compact 110 | Int field collapse with short, bright hor line | Dry joint A1/focus earth pin on LOPTx | 14-09-04 |
| Goodmans | Compact 110 | Line collapse | CH01 4µ7 50v bipolar o/c | 14-09-04 |
| Goodmans | Compact 110 | Line collapse & no sound | Dry joint LH01 | 14-09-04 |
| Goodmans | Compact 110 | St/by only | ZP06 8v2 zener (set had been connected to 12v wrong way round) - Mk 1 version | 14-09-04 |
| Goodmans | Compact 110/2 | No sound/pic with LED lit & 12v present | DH04 s/c pt no ACTI13051025 | 14-09-04 |
| Goodmans | Compact 210 | Dead - no o/p from PSU | DS07 9v zener & DS08 8V2 zener & SMPS Tx Pt no ACTI39400067& | 14-09-04 |
| Goodmans | Compact 210 | No front control - R/C OK | ICR1 Micro faulty - if old type M34300-012SP then ICR2 must be fitted | 14-09-04 |
| Goodmans | Compact 210 | PSU blow up | Caused by yellow sealant becoming conductive on print side of PSU | 14-09-04 |
| Goodmans | Compact 210 | St/by only | CS12 3300µ 35v | 14-09-04 |
| Goodmans | Compact 210 | Tuning drift | Low volts on DI02 33v reg due to low HT - Cp28 470mfd 16v o/c | 14-09-04 |
| Goodmans | Compact100 | hum bar when heated | 1N5402 rect diode o/c | 14-09-04 |
| Goodmans | Compact110 | Line drive int | CH03 10mfd 25v | 14-09-04 |
| Goodmans | Compact110 | Whistling/whining in st/by | Reg 10.8v not dropped to 0v - Micro pin30 not shutting off reg (should be 12v in st/by) - micro faulty | 14-09-04 |
| Goodmans | Compact110 | Won't go into st/by | CR02 0.1mfd o/c | 14-09-04 |
| Goodmans | Compact110/2 | Line collapse | Dry joints LH01 & CH01 in line coil coupling | 14-09-04 |
| Goodmans | CT2045TS | Tripping - LED flashes in time - low HT | C409 470pF 1kv in LOP | 14-09-04 |
| Goodmans | CTV2 ( T ) | Blank raster - sound Ok. | IC204 ( TDA3562A ) | 14-09-04 |
| Goodmans | CTV2 ( T ) | Dead - HT Ok. | Line drive Tx ( Pt No.ABATETH19Y19BY ) | 14-09-04 |
| Goodmans | CTV2 ( T ) | No sound or raster - display Ok. | Q103 ( CL155D ) s/c , R181 ( 5.6R 5W ) o/c. | 14-09-04 |