| Make | Model | Problem | Solution | Date |
| | | |
| Found: 749
|
| Goodmans | 2575 | SEVERE BLACK BANDS ACROSS PICTURE SOUNDS LIKE LINE | TUNER ( PLUG IN SCART PLUG TO PROVE ) | 14-09-04 |
| Goodmans | 2575 | WON'T SWITCH ON FROM COLD | REPLACE C102 IN POWER SUPPLY | 14-09-04 |
| Goodmans | 2575 F11 | Dead apart from whine from psu | Dry joint C134 in LOP & s/c LOP Tr S2055N | 14-09-04 |
| Goodmans | 2576 | E/W faulty | IC18 TDA4950 | 14-09-04 |
| Goodmans | 2580 | Sound missing | TS90 BC848B sm in sound mute stage | 14-09-04 |
| Goodmans | 2580 TX92 | Appears to have field coll with bright line near top | TP91 BC848B & TP96 BC858B sm in psu | 14-09-04 |
| Goodmans | 2580 TX92 | Line tearing aft warm up - bad on Txt | Internal arcing of EHT lead at LOPTx end - make sure of a good contact | 14-09-04 |
| Goodmans | 2580 TX92 | Sound missing | TS90 BC848B sm | 14-09-04 |
| Goodmans | 2580(TX92) | LINE TEARING AFTER SET WARMS UP | CHECK EHT LEAD IS FULLY SLOTTED INTO LOPT | 14-09-04 |
| Goodmans | 2580/2880 TX92 | Dead - tripping Led flashes once per sec | TP22 BC337 in PSU | 14-09-04 |
|
|
| Goodmans | 2580/2880 TX92 | Int sound or screeching with pic present | Dry joints IP08 | 14-09-04 |
| Goodmans | 2580/2880 TX92 | No R/C | GM01 has narrow acceptance angle - replace | 14-09-04 |
| Goodmans | 2580/2880 TX92 | No sound | TS90 Tr | 14-09-04 |
| Goodmans | 2580/2880 TX92 | No sound | TS90 sm BC848B | 14-09-04 |
| Goodmans | 2580/2880 TX92 | St/by only | RP62 2R2 | 14-09-04 |
| Goodmans | 2580A/2880A ICC9 | Field cramp at top - int | DF31 - replace with BA157 | 14-09-04 |
| Goodmans | 2595TN | Will not go into StBY | Replace R105 & R106 ( 150K ) | 14-09-04 |
| Goodmans | 2808 ICC9 | No tuning - ok thro' SCART | TH01 BC847B sm | 14-09-04 |
| Goodmans | 2808 ICC9 | White streaks over screen | TC03 BC858B sm lum buffer | 14-09-04 |
| Goodmans | 285 | Dead - burnt parts in Hor sync line etc | faulty jungle ic; C 416 680 pf s/c; D506 s/c; RC527 sm res o/c 10R; D504 s/c & TDA8375A | 14-09-04 |
| Goodmans | 2850DPL | Blank raster & flyback lines, sound & osd ok | CK53 12µ 63v in LOP stage | 14-09-04 |
| Goodmans | 285DPL | "Put put" noise in st/by | WA21 zero ohm link on Dolby module - remove it | 14-09-04 |
| Goodmans | 285DPL | Arcing effect on pic, int field & blanking out | Dry joint LOPTr heatsink | 14-09-04 |
| Goodmans | 285DPL | ARCING ON PICTURE | RESOLDER LINE O/P TRANSISTOR HEAT SINK | 14-09-04 |
| Goodmans | 285DPL | BLANK RASTER WITH SOUND | REPLACE C416,R409,R503 AND D506 | 14-09-04 |
| Goodmans | 285DPL | Dead - no sec volts after psu rebuild - LED rapid flash | C012 10µ 25v s/c - removes start & run supply to N010 pin 16 | 14-09-04 |
| Goodmans | 285DPL | DEAD WITH STANDBY LIGHT FLASHING | REPLACE RK68 AND VK71 | 14-09-04 |
| Goodmans | 285DPL | E/W dist with lack of width | RK62 not soldered properly | 14-09-04 |
| Goodmans | 285DPL | E/W dist with lack of width | RK62 15R o/c, NS10 TDA8350Q faulty - check V508 diode lead hasn't s/c to RK62 | 14-09-04 |
| Goodmans | 285DPL | EHT COMES UP THEN SET SHUTS DOWN | SUSPECT LOPTX | 14-09-04 |