| Make | Model | Problem | Solution | Date |
| | | |
| Found: 749
|
| Goodmans | F11 2875 | Dead with TR15 S2000N S/C | Replace S2000N and C102 100ufd which was down to 20ufd | 14-09-04 |
| Goodmans | F11 2875 | Flat looking pic with one or more cols missing | Check feedback res R26, R28, R29 68k on crt base | 14-09-04 |
| Goodmans | F11 2875 | Won't sw back on after st/by selected | Check all elects in psu pri | 14-09-04 |
| Goodmans | F11 2876 | Low emission crt symptom | Check feedback res R26, 28 & 29 68k on crt base | 14-09-04 |
| Goodmans | F19 336NS | Burning smell although working ok | C134 LOP tuning cap 17.4nF | 14-09-04 |
| Goodmans | F19 336NS | Int dead with st/by LED absent | C105 8.2nF 160v | 14-09-04 |
| Goodmans | F19 336NS | Red tint - if col reduced still present if contr reduced absent | IC9 TDA8361A | 14-09-04 |
| Goodmans | F19 336NS | Vol stuck at min or max | IC131 24C04 EEPROM | 14-09-04 |
| Goodmans | F19 Proline 28N1 | high freq whistle | replace L3 mains suppression coil (Formenti part no 88700503131) | 14-09-04 |
| Goodmans | F19 Proline 28N1 | no pic, sound OK | no 200V to CRT, D27 (Formenti part no 88710202002) and L23 o/c (88700503135) | 14-09-04 |
|
|
| Goodmans | F19 W280NS | Dead | Volts on IC1 pulsing & no volts pin 1 - R7 10k hi res | 14-09-04 |
| Goodmans | F19 W280NS | No sound | Put set in service mode & press vol up button | 14-09-04 |
| Goodmans | F19 W280NS | No vol adj or sound menu | Dry joints Skt A13 on main pcb from NICAM panel | 14-09-04 |
| Goodmans | F19 W288NS | Dead | Sw mode Trfmr o/c feedback winding | 14-09-04 |
| Goodmans | F19 W288NS | Dead | R170 0R1 in 26v supply o/c | 14-09-04 |
| Goodmans | F19 W288NS | Dead - mains fuse blasted | Mains rects s/c & chopper transformer shorted also TDA4601 chopper chip | 14-09-04 |
| Goodmans | F19 W288NS | Dead - no o/p from PSU | L13 not soldered properly | 14-09-04 |
| Goodmans | F19 W288NS | Dead - very low volts on IC14 in smps | D36 BA157 s/c in psu | 14-09-04 |
| Goodmans | F19 W288NS | Dead with HT between 5 - 100v with chopper Tr overheating | D37 1N4148 leaky or s/c | 14-09-04 |
| Goodmans | F19 W288NS | E/W fault & lack of width | C71 1UF 100v (very bulged and burnt) + L20 10m/h coil | 14-09-04 |
| Goodmans | F19 W288NS | No sound | R231 o/c & C050 u/s | 14-09-04 |
| Goodmans | F19 W288NS | St/by only | R177 1R in 16v supply o/c | 14-09-04 |
| Goodmans | F19 W288NS | St/by only | D37 1N4148 s/c, C108 1µ 100v o/c | 14-09-04 |
| Goodmans | F19 W288NS | Tripping | SMPS Tx Pt no FORM88700402149 | 14-09-04 |
| Goodmans | F19 W288NS | Width closes in gradually then LOPTr goes s/c | Dist line dr wfmr caused by Line dr trfmr - was able to clean/resolder pins | 14-09-04 |
| Goodmans | F19 W288NSA | No sound just a crackle & buzz | IC3 TDA9875A on NICAM PCB | 14-09-04 |
| Goodmans | F19 W321NS | E/W dist IC18 TDA4950 overheating | C138 100nF 63v o/c & check IC18 | 14-09-04 |
| Goodmans | F19 W321NS | Int shut down | Check pins on IC12 are properly connected to pcb | 14-09-04 |
| Goodmans | F19 W321NS | Pic blanks in zoom mode | R25 3k3 1w on scan corr pcb | 14-09-04 |
| Goodmans | F19 W321NS | Sound int uncontrollable with howl | Dry joints NICAM skt on main pcb | 14-09-04 |