| Make | Model | Problem | Solution | Date |
| | | |
| Found: 1771
|
| Ferguson | B59F | Slight green cast to picture | Replace open circuit 1k 0.5w (RT66) on crt panel | 14-09-04 |
| Ferguson | B59F | Tuning drift & loss | Resolder tuner & replace TH01, TH02, TH03, TH04 and TH05 | 14-09-04 |
| Ferguson | B59F (ICC8) | POOR PICTURE WITH STREAKS | CHECK R704 1.5K OHM ON CRT BASE | 14-09-04 |
| Ferguson | C3615U Combi | Switches off aft 10 secs with tape jammed | RW002 1R 1w safety res on deck pcb - also check fuse link FW003 (behind on/off sw near white ribbon conn) | 14-09-04 |
| Ferguson | C3615UT | Hotel mode removal | Press simultaneously on the PR-, STOP and AC on/off button on the front of the combi. Adjust using arrow keys on the remote, press ok. | 14-09-04 |
| Ferguson | C3615UT | Hotel mode reset | Press PR-, STOP & AC on/off button on front of combi. Adj using arrow keys on R/C, press ok. | 14-09-04 |
| Ferguson | C3615UT | No R/C response | 3 legged IR Rx faulty | 14-09-04 |
| Ferguson | C3615UT | Txt int lost | QX51 27Mhz Xtal on Txt pcb replaced | 14-09-04 |
| Ferguson | C51F | Bright raster with fb lines | TB11 BC557 on crt base leaky - check LOPTx (HR7269) wasn't the cause of its demise | 14-09-04 |
| Ferguson | C51ND | NO SOUND | CHECK HEADPHONE SOCKET | 14-09-04 |
|
|
| Ferguson | D51ND | STUCK IN STANDBY OR BLANK RASTER | REPLACE TR81 SMD BC858C | 14-09-04 |
| Ferguson | D51ND | WILL NOT SWITCH ON FROM STANDBY OK FROM SWITCH | REPLACE CP14, DP34, AND IP01 IN POWER SUPPLY | 14-09-04 |
| Ferguson | D59N (ICC9) | INT WON'T COME OUT OF STANDBY | REPLACE IP03 9V REG | 14-09-04 |
| FERGUSON | D59N (ICC9) | NO SYNC ON SCREEN GRAPHICS | REPLACE TR42 BC848 (SMD) | 14-09-04 |
| Ferguson | D68N | NO BLUE | REPLACE RB71 1.5K OHM | 14-09-04 |
| FERGUSON | D68N | NO VIDEO FROM TUNER OR SCART SOCKET | REPLACE TX09 BC858 (SMD) | 14-09-04 |
| Ferguson | D68N | Various micro lock up - int no sound & entering install menu at random | Replace EEPROM & front membrane & set up | 14-09-04 |
| Ferguson | D78N (ICC9) | PULSING RED/GREEN LED | CHECK SMD DIODE DP83 OFF PIN1 OF IP03 | 14-09-04 |
| Ferguson | DFS68NX IDC2 | Pic gradually goes bright with fb lines then trips | RT06 1M under A1 pot o/c | 14-09-04 |
| Ferguson | DSF68NX | Patterning on pic & hum on sound until heated | CG03 4µ7 100v behind LOPTx | 14-09-04 |
| Ferguson | F14VB12A | Sound int lost | IS001 switching chip 101-22-010 | 14-09-04 |
| Ferguson | FG20CB22U | Switches itself off aft 10 mins | Replace 4 elects in pri of psu | 14-09-04 |
| Ferguson | ICC17 / 19 | Service mode access | Go to St/By, turn set off using power switch. When red LED goes off, hold down prog- and vol- keys on T.V and power up keeping both buttons held down for at least 8 seconds until STANDBY light goes yellow. To navigate through the menus use the arrow keys.To exit service mode put T.V into standby. | 14-09-04 |
| Ferguson | ICC17 M6322 | Trips , LED flashes 7 times then goes to st/y | TL02 BF422 leaky | 14-09-04 |
| Ferguson | ICC17 M8422U | Dead with mains fuse blown | DP06 BZW04-342 across mains rect cap (not shown on all cct diags) | 14-09-04 |
| Ferguson | ICC17 W7023U | Dead | LOPTx faulty - had brown gunge on the top - replacement comes with 2coils, 2 caps & 4 sm res | 14-09-04 |
| Ferguson | ICC17 W7023U | Trips at sw on with led flashing 3 then 2 then 7 then 2 flashes then reverts to perm illum | LOPTx faulty- check for brown gunge on top - also obtain mod kit (psu will not run unloaded) | 14-09-04 |
| Ferguson | ICC19 Thomson 32WS83KP | starts up then trips and shuts down | IB01 TEA5101B on CRT | 14-09-04 |
| Ferguson | ICC5 | 3 COLOURED FLYBACK LINES TOP OF PIC | CHECK DL21 THYRISTOR ( MAY HAVE SCAN COIL RATTLE ) | 14-09-04 |
| Ferguson | ICC5 | 3 lines of scan at top of pic only | IL14 TEA2029 jungle chip | 14-09-04 |