Make | Model | Problem | Solution | Date |
| | | |
Found: 1771
|
Ferguson | IKC2 | Going in to standby after few Seconds. | DL11 ( BA157 ) s/c , RL11 ( 15ohm ) o/c LH side of LOPTX. | 14-09-04 |
Ferguson | IKC2 | H.T. correct at switch on with no line output oper | Check pin 40 IV01 ( T8659 ) 9V = on 0V = StBy trip Volts come from TR17 maybe o/c | 14-09-04 |
Ferguson | IKC2 | Int st/by aft long time | TV01 BC558C & TV02 BC548C transistors | 14-09-04 |
Ferguson | IKC2 | Low brightness - doesn't alter with OSD | TT33 on crt base | 14-09-04 |
Ferguson | IKC2 | No results no standby LED. | DP50 ( BY399 ) o/c. | 14-09-04 |
Ferguson | IKC2 | No startup. | TR16 ( BC548B ) , TR17 ( BC558B ) | 14-09-04 |
Ferguson | IKC2 | Off with bang | mains fuse shattered, on/off sw siezed - caused by degaus positor | 14-09-04 |
Ferguson | IKC2 | St/by only aft brief rush of EHT | IF01 TL082 field dr chip faulty - no pulses coming out - only dc which turned fop thy hard on | 14-09-04 |
Ferguson | IKC2 | Standby - Locked in Standby. | Press Programme Up button on front unit for 6 seconds. | 14-09-04 |
Ferguson | IKC2 | Standby - switching to standby on channel ch. | Replace 2.2k RP26 with a 1.5k if any lower blows S2000AF | 14-09-04 |
|
Ferguson | IKC2 | Tripping | TV01 ( BC558 ) , AND FIELD O.P. CHIP IF01 | 14-09-04 |
Ferguson | IKC2 | Tripping ( red LED ) at 1 second intervals. | TV01 ( BC558 ) leaky , due to LOPX. | 14-09-04 |
Ferguson | IKC2 | Tripping - standby light lit. | DL11 ( BA157 ) s/c , res RL11 o/c. | 14-09-04 |
Ferguson | IKC2 | Trips off at sw on | TL082 op amp IC | 14-09-04 |
Ferguson | IKC2 | Trips slowly ( once per second ) no obvious shorts | TV01 ( BC558 ) check by replacement | 14-09-04 |
Ferguson | IKC2 | WONT COME OUT OF SBY , WORKS IF FIELD COIL PLUG RE | DF16 BY398SC. | 14-09-04 |
Ferguson | IKC2 A51F | Dead - LED flickers twice briefly | LOPTx | 14-09-04 |
Ferguson | IKC2 A51F | Sound low | Weak audio o/p at pin 10 IF can, CS14 1µ 63v in the can low cap | 14-09-04 |
Ferguson | IKC2 A51F | Tuning mode | press and hold the PROG button in for a few seconds B4 it displays the on screen graphics. To unskip channels; display the tuned station by pressing PROG for a few seconds and then press the red fasttext button to store. | 14-09-04 |
Ferguson | M6373GCT TX91G | No or intermittent TeleText | Check for dry joints on IX02 Reg IC on the small Text pcb. | 14-09-04 |
Ferguson | M7073GH | Bright white pic with poor focus | Altering focus control affects amplitude of video at crt cathodes - CRT faulty | 14-09-04 |
Ferguson | M8421U ICC17 | Dark bands running up screen with corrugation/pulling in the bands | Fit Line output transformer kit (35096370)
Notes: The LOPT kit consists of a new transformer (10608640) to replace the original (10516050) for this 33" medium planartube (MP), plus a 100k 0.1w surface-mounted resistor to replace RL48 (76k8). | 14-09-04 |
Ferguson | RP46 | Dead - st/bt led comes on briefly & buzzing from chopper tfmr | Overload on lop caused by EHT splitter shorted | 14-09-04 |
Ferguson | RP46 (Proj TV) | No Red | R615 [910K] open circuit - in series with the red A1 preset | 14-09-04 |
Ferguson | RP46 (proj) | Red pic at sw on then shuts down | RG18 680k on sub G2 board o/c | 14-09-04 |
Ferguson | RP46 (proj) | Vol level varies on its own | CR11 o/c - near IR01 | 14-09-04 |
Ferguson | RP46 rear proj | No convergence | RP09 100k or RP18 220k o/c in conv psu near blue tube | 14-09-04 |
Ferguson | T10RW T6X90- | Low sound - not in Hotel mode | C506 470µ 25v leaky | 14-09-04 |
FERGUSON | T49F | STUCK ON STANDBY | CHECK DL05 FOR LEAK DIOD1S1834 | 14-09-04 |
Ferguson | T49F/TX91 | HEIGHT DECREASES AFTER 1 HOUR | REPLACE CF06 100MFD50V | 14-09-04 |