| Make | Model | Problem | Solution | Date |
| | | |
| Found: 1771
|
| Ferguson | ICC7 | Bright raster with fb lines | TT33 BC558 on crt base caused by CW01 680nf on sub panel dry jointed | 14-09-04 |
| Ferguson | ICC7 | Clicking sound on NICAM - ok on mono | 16.384khz Xtal on NICAM pcb | 14-09-04 |
| Ferguson | ICC7 | Comes out of standby then goes off. | Check DP54 DP55 RP62 ( 0.1ohm ) DF16 ( BA157 ) DL18 TL18 TP29 TP17 | 14-09-04 |
| Ferguson | ICC7 | CRACKLING NOISES FROM CABINET | FIT MOD KIT Pt No 00P3142010 | 14-09-04 |
| Ferguson | ICC7 | Dark & predominately magenta | 3 x 39k res on crt base | 14-09-04 |
| Ferguson | ICC7 | Dead | RP62 oc. ( PIN 14 S/MODE. ) FIELD CHIP FAULTY | 14-09-04 |
| Ferguson | ICC7 | Dead | Check TP29 : TL19: DP50 : CP22: DP17 : DP28: | 14-09-04 |
| Ferguson | ICC7 | Dead | IP01 TEA2261 | 14-09-04 |
| Ferguson | ICC7 | Dead | LOPtr S2000AF s/c - dry joints caps in line stage | 14-09-04 |
| Ferguson | ICC7 | Dead | Mains sw; IR01 micro | 14-09-04 |
|
|
| Ferguson | ICC7 | Dead - brief Led lights at sw on | CP59 3300µ leaked onto print corroding track | 14-09-04 |
| Ferguson | ICC7 | Dead - eht comes up then off with screech | Corrosive glue under RP39 120k had eaten away print | 14-09-04 |
| Ferguson | ICC7 | Dead - LED red for about 10 seconds then out. | TL17 s/c , DF16 ( BA157 ) , DL18 ( 1N4148 ) | 14-09-04 |
| Ferguson | ICC7 | Dead - LED shines red. | RP62 ( 0.1ohm ) o/c , TDA8178F frame IC IF01. | 14-09-04 |
| Ferguson | ICC7 | Dead - lopt tr s/c | check CL21 ( usually 11 nF ) in this case it was down to 12 pF ! | 14-09-04 |
| Ferguson | ICC7 | Dead - loptr s/c | Replace with S2000N & tuning cap | 14-09-04 |
| Ferguson | ICC7 | Dead - no LED lit - set tripping. | DP17 ( BA157 ) s/c. | 14-09-04 |
| Ferguson | ICC7 | Dead - no O/P from PSU. | CHECK DP 28 ON PRIMARY , BA157 - BA159 | 14-09-04 |
| Ferguson | ICC7 | Dead - psu ticking | RP62 0R1 o/c; IF01 TDA8178F S/C | 14-09-04 |
| Ferguson | ICC7 | DEAD , NO LED , TRIPPING | DP17 BA157 ( PRODUCES EOR VOLTS FOR PIN 6 OF IP01 ) | 14-09-04 |
| Ferguson | ICC7 | DEAD , LED SHOWS RED | CHECK 1st RP62 0.1ohm 24v. OR IF TDA8178F , FIELD IC ( MAY NOT RUN WITH IC DISCONNECTED , REPLACE! ) | 14-09-04 |
| Ferguson | ICC7 | DEAD , LINE OSC WONT START. | IRO1 MICRO ( ST 6391B1/BC ) PtNo IOO35850 | 14-09-04 |
| Ferguson | ICC7 | DEAD FUSE FP01 OC CHOPPER TP29 SC | IP01 TEA2261 + RP62 OC 0R1 | 14-09-04 |
| Ferguson | ICC7 | DEAD HT - LINE DRIVE RISES - DIES | CHECK LINE DRIVE AMPLITUDE | 14-09-04 |
| Ferguson | ICC7 | Dead HT present | 3300µ 35v cap behind loptx leaked & corroded adj track | 14-09-04 |
| Ferguson | ICC7 | DEAD LED LIGHTS FOR 8-10 SECS THEN GOES OUT | SCOPE LINE DRIVE AT PIN 39 TA8659 , IF OK , CHECK at base Tl17 ALSO CHECK DF16 , DL18 | 14-09-04 |
| Ferguson | ICC7 | Dead No LED | Check V at pin 16 TEA2261 if low 1.6V replace DP28 ( BA157 ) | 14-09-04 |
| Ferguson | ICC7 | DEAD NOT TRIPPING | RP62 OR1 DL09 SC | 14-09-04 |
| Ferguson | ICC7 | Dead standby LED on. | CHECK LINE DRIVE O/P.CHECK PIN 20 IRO1 , SHOULD BE HIGH TO START IVO1 | 14-09-04 |
| Ferguson | ICC7 | Exitting factory mode | switch off set, hold in both
volume buttons on the set whilst switching back on | 14-09-04 |