| Make | Model | Problem | Solution | Date |
| | | |
| Found: 1771
|
| Ferguson | TX100 | Will only tune on channel 1 & 8. | IC905. | 14-09-04 |
| Ferguson | TX100 | WONT CHANGE CHANNELS WHEN COLD | C261 ( 1mfd ) | 14-09-04 |
| Ferguson | TX100 (Turkish) | Switches to Stby after a while. | Change two 5V regulators in the control board.(TDD1605) | 14-09-04 |
| Ferguson | TX100 59J7 | Field collapse | FOP chip TDA3652 - check for dry joints at scan coil plug under plastic cross member | 14-09-04 |
| Ferguson | TX100 Chassis (Turkish) | Switches to Stby after a while. | Change two 5V regulators in the control board.(TDD1605) | 14-09-04 |
| Ferguson | TX80 | buzzing, narrow pic, "lock" displayed | DP15 1N4001 o/c connected in series with chopper/lop tr TP10 | 14-09-04 |
| Ferguson | TX80 | Child lock release | sw to st/by then on again with r/c | 14-09-04 |
| Ferguson | TX80 | Dead | DP65 SC FUSE FB072 OC | 14-09-04 |
| Ferguson | TX80 | Dead | check RP01 27K 3 W | 14-09-04 |
| Ferguson | TX80 | Dead - faint sound of tripping . If unplugging sma | Change D710 on inverter pcb ( may measure ok ) | 14-09-04 |
|
|
| Ferguson | TX80 | If PSU has blown up. | Check RP01 ( 27k , 3w ) gone high. | 14-09-04 |
| Ferguson | TX80 | INT RED | CRACK IN PRINT BETWEEN RV110 AND TV01 EMITTER ( OR crack in print between RV110 & RV104 ) | 14-09-04 |
| Ferguson | TX80 | INTERCAIER BUZZ , MAY BE INT | 6 Mhz CERAMIC FILTER Q102 | 14-09-04 |
| Ferguson | TX80 | loud buzzing only | o/c print between pin 6 of chopper tfrmr LP03 & RP50 | 14-09-04 |
| Ferguson | TX80 | MAINS FUSE SHATTERED NO OBVIOUS SHORTS | DEGAUSSING POSITOR US | 14-09-04 |
| Ferguson | TX80 | No sigs after replacing ae skt | 1k chip resistor dropped off board inside tuner | 14-09-04 |
| Ferguson | TX80 | Striations on screen & off tune | 27K next to lopt (33volt dropper resistor) | 14-09-04 |
| Ferguson | TX80 | Stuck in standby. | Check RP36 ( 75k , 2w ) gone high. | 14-09-04 |
| Ferguson | TX80 | Stuck in Standby. | RP36 ( 75K ) 2 Watt | 14-09-04 |
| Ferguson | TX80 | Weak, narrow raster with buzz & hum bar | DP15 1N4001 o/c in base TP10 | 14-09-04 |
| Ferguson | TX80 | Tubey and green | dry joint on jumper JT05 9v feed to base of 2 of the o/p trs | 14-09-04 |
| Ferguson | TX80 B14R | Dead, whistling | RP68 0R68 o/c - in 13v feed | 14-09-04 |
| Ferguson | TX80 B14R | Humbar at LH side of screen & TP10 LOPTr overheating. | DP 30 DP15 DP16 IN4001 diodes, one or all open circuit | 14-09-04 |
| Ferguson | TX80 B14R | Int Fback lines | DF04 BA517 | 14-09-04 |
| Ferguson | TX80 D14R | Int blows excess volts prot diode DP50 ZPU150 | Dry joint at wire link from pin 5 LOPTx | 14-09-04 |
| Ferguson | TX805 | Blank raster | M52038SP multifunction chip IL01 | 14-09-04 |
| Ferguson | TX805 | bright pic with fb lines | 10R safety res for 150v supply o/c & CP22 22µ 100v dried up | 14-09-04 |
| Ferguson | TX805 | Dark pic with ringing | dry joint at Y I/p on crt base | 14-09-04 |
| Ferguson | TX805 | Dead | CHECK RP41 - RP44 68Ks | 14-09-04 |
| Ferguson | TX805 | Dead | CHECK RP 41 , 42 , AND 44 150k AND 120k IN PARALLEL. | 14-09-04 |